Fordson Super Dexta Engine | PART 1: Stripping Down The Engine

Welcome back! Apologies for the break, it took a while to get my workshop up and running but now we are back with a new series. Follow along as we strip this Fordson Dexta Engine!
Big Thank You to EMMARK UK for sponsoring this video: www.emmarkuk.com/
Get in touch if you are looking for parts for your own projects and I can supply those for you:
My email: [e-mail]
My Instagram: / kevinrix_norfolktractors

[@BundyBearsShed]

I just bought a little Dexta for Bundy Bears Shed

[@kevsvintagetractorrepair]

Hi how's it going, nice little tractor thought it would make a good video to show the differences between the Dexta and the MF35 3 cylinder engine.

[@vehicle_entrance]

No Lance, it'll have to be a diesel TE20 first! 😂

[@jeepeeam31]

Hi and tgis video came right on time. Im rebuilding Super Dexta engine during this winter. Following You!

[@kevsvintagetractorrepair]

Hi thank you for your comment glad to have you on board. Hope you find the video helpful.

[@paulcarolinecolesmith-yr3kn]

Hi Kev great to see you and your looking well and got the new workshop sorted it’s fantastic to see that you’re now doing more informative videos again and with super dexta engine and look forward to seeing more 👏👌👍

[@kevsvintagetractorrepair]

Hi Paul hope you're ok, glad you are enjoying the videos so far there will be a few more coming soon.

[@paulcarolinecolesmith-yr3kn]

@@kevsvintagetractorrepair we’re fine thank Kev 👍

[@ibrahimkani7064]

Very useful fo me

[@kevsvintagetractorrepair]

Hi thank you for your message glad it’s going to be useful to you.

[@kevinloonam2567]

nice to have you back

[@kevsvintagetractorrepair]

Thank you it's nice to be back.

[@JACKATTACKED]

The wee welder dude is watching intently 😂

[@kevsvintagetractorrepair]

Glad to have you onboard.👍

[@barnmechanic2952]

The combustion chambers warp around the bolt holes because the original gasket only covers the center part. When tightened down you get uneven pressure. Just replace them or file around the bolt holes and the outer edge.

[@kevsvintagetractorrepair]

Hi thank you for your comment great tip thank you I know from the past they can be a pain to seal🤬

[@basedpeasant5070]

When we went through the head of our MF35X we were unable to make the pre chambers seal properly with the normal gaskets since you can’t get enough pressure on it all. So instead we bought copper and aluminum washers with the dimensions 33.3x38.9x2mm, that way it seals inside on the cup instead. We put copper and a new cap on one, copper and old cap on one and aluminum and new cap on one and 250 hours later they are all still tight, no mystery goo used.

[@kevsvintagetractorrepair]

Thank you for your comment I’ve had problems with them in the past thank you for your advice.