Fusion 360 - Cylinder needs an Angled Face (Draft)

This is from a Reddit question on how to add an angle to the end of a cylinder.

[@Hetreks]

Helpful, thank you very much.

[@oldman_eleven]

Thank you so much. Concise and accurate.

[@enterusernamefuck]

Great demo. Thanks for all you do Kristian!

[@KristianLaholm]

Thank you

[@georgesolomon5696]

Thank you for the video, very helpfu. But what if I had specific length for each side of the cylinder. For example one side is 20mm and the other is 15mm? Is there a way to do a slope by length instead of angle?

[@KristianLaholm]

In that case I'd do a sketch from the side and extrude cut the angled face.