Fusion CAM Live Turning Series 08 - SubSpindle Transfer

[@matthewhall1045]

Excellent series. I’ve learnt a lot from this.

[@KerryHarrison-Woodturning]

Excellent series Mike! One question if you don't mind. When I open the turning menu I do not have the two secondary spindle OPs that you have. Any idea how I can get them to show up? Thanks!!

[@Vitae_Essence]

Did you model up that Chuck or did you get it online?

[@christophercolumbus8944]

did you use to work for mastercam before? your sound is familiar

[@mikemattera6724]

yes.

[@pagodaa100]

Mike, Nice video. I am getting ready to swap out our Haas ST10 for a ST10 with a sub and have begun looking for some instruction. My HFO is going to help me out with getting a post processor set up so hopefully that part is a non issue. This video is fantastic but I do have a question on the part off operation. To me it looks like you have the tool approaching in a way that would collide with the sub spindle? or am I missing something. Thanks in advance!

[@stevendavies2407]

What about using the sub spindle to pull bar stock from the main so after part off, the first op is ready to run again. Bar feed with out a bar feeder. To clarify, Sub moves in and clamps the part, main unclamps, sub retracts a specified amount, main clamp, part off, sub home.

[@TECH-mp4fq]

good video sir

[@williamfisher6205]

This is a great video, and I found the tutorial files for this part online, but the secondary spindle function feed planes are wrong in the tutorial. Can you explain why?

[@Scott-ew7bz]

i think i have same issue. any luck?

[@christophercolumbus8944]

@@Scott-ew7bz what are you having problems with ?

[@Scott-ew7bz]

When i get to this point it shows my planes going in the x axis.... what am i doing wrong?