FX Crown MK1 disassembly UK spec

[@luisferreira633]

Very enjoyable to watch a very talented man at work making his own tools and gun parts. Keep them good videos coming mate 👍👍👍👍

[@sub12airgunners]

Thanks much appreciated, glad you enjoyed it. Thanks for watching.

[@johnward9155]

How do you polish the dent out of the Reg Piston , mine has the same .Very informative videos Sir

[@pearsonmutambirwa9308]

Hie there. Just a quick question, did you figure out how to polish the dent on your reg piston?

[@lisawood516]

I like your home made tools. They are very handy!! 😁

[@sub12airgunners]

Glad you like them!

[@sunflowerisland]

Where can I get the material to make a piston puller, what's the ID of the puller? Thanks

[@pearsonmutambirwa9308]

I was stripping mine while watching your video and I noticed that my reg piston has a dent also, so i wondering if you could please help with info on how to polish the dent out? Thanks for the nice informative videos

[@benameeralmnthari9425]

Sir, how can I obtain the tool used for piston extraction? I'm having difficulty getting the spade out. Can you give me an idea?

[@andrenunes8077]

Olá, teria como ser feito um power plenum para FX CROWN ?

[@numizaairguns1373]

No word just Great as always...

[@sub12airgunners]

Thanks again!

[@jonahchua]

@Sub12 Airgunners great video. I just watched the hammer polish video and was wondering how the hammer doesn’t wobble after removing the material. Is the hole for the hammer smaller near the valve? Thanks

[@sub12airgunners]

I talked a little about this issue in the video I am making at the moment, it would wobble technically, but the hammer spring is inside the hammer and the anchor point of the spring is up the front of the hammer so the rear of the hammer is being pulled forward, so it straightens itself up as it travels the bore. Also my standard hammer was not a tight fit in the action, it had a fair bit of rattle room around it. I think the main reason FX shaped the hammer the way they did is to give some protection with the FAC set up, if you fire the rifle with the bolt open with the FAC set up, the hammer on this rifle would have a big dent in it. Thanks for your question and thanks for watching.

[@jonahchua]

@@sub12airgunners Thanks so much for the reply, that helped a lot. Looking forward to the new video

[@chrisfigueroa3361]

Awesome video man I really enjoy watching these kinds of videos... its like therapy to me cus I like doing the same .. taking my air guns apart just to see how they work ... I noticed on my new fx m3 that it dies not have a value sit in the real block tell me if im wrong thanks for sharing bsafe

[@sub12airgunners]

Is it an FAC? The FAC rifles should have a one piece seat installed in the back, but the Sub 12 rifles typically (not always) have the separate seats. Thanks for watching.

[@chrisfigueroa3361]

@@sub12airgunners yes FAC 👍 maybe it did have it but I didn't see it 😕 I was installing slug kit

[@jonmo4134]

Terrific instructional videos and a great communicator. Must see for anyone wanting to work on their FXs. My Crown can only manage 7ft/ilbs so clearly requires surgery. The piston removal tool looks like an essential tool. Is this a bespoke made item or something I can buy in the market?

[@sub12airgunners]

bagnal & kirkwood sell them 😀

[@jeffhello1444]

nice work 👌👏

[@sub12airgunners]

Thank you! Cheers!

[@eoinwestman6222]

Very good video. Thank you.

[@sub12airgunners]

Glad you liked it! Thanks for watching.