FX Wildcat | JSB 18.13 Pellet | 100 Yards | Quick Tune | Session #54

[@ScrotalsbySackington]

Nevermind. Realized your effin around with qt system. Carry on

[@ScrotalsbySackington]

You want the shot to sound like a spitball. Just a quick gentle low pitch puff. I'm hearing a high pitch whip crack, turbulent air makes the pellet unstable

[@hectormanuelmh]

That is the test I wanted to do but my WC is 500mm, maybe a 21-22 grains can work better, thanks for the video

[@ShootingWithPhil2023]

@hectormanuelmh 21 grain is the next video, but with the 600mm barrel.

[@ScrotalsbySackington]

I would diagnose too high a dwell. Your spread and consistency is fantastic tho.

[@JohnHowerton223]

Run the reg up to 80 and repeat. Seems like maybe those reg pressures are too low unless you did a lighter spring and hammer. I bet 80-85 bar the gun will feel a lot more balanced/tight even though it was shooting amazingly consistent.

[@ShootingWithPhil2023]

Ok, I just shot that video. Will take me a few days to edit. How do you think it turned out?

[@JohnHowerton223]

@@ShootingWithPhil2023 the 80+ bar video? With stock internals I would suspect good.

[@JohnHowerton223]

@@ShootingWithPhil2023don’t most of the Pros shoot the 18 Heavy at 880? Only 10fps but I’ve seen crazier 😂

[@ShootingWithPhil2023]

@@JohnHowerton223 yes stock internals. You'll have to wait for the results. Makes for a good comparison between Impact and Wildcat.

[@joeharrold]

Phil. Is there a way to get in touch with you offline? I have your quick tune system for my Maverick. I have some questions. Thanks

[@ShootingWithPhil2023]

@@joeharrold [e-mail]

[@ScrotalsbySackington]

Try detuning and backing the BS all the way back and starting at 1 on the wheel at 95bar. I shoot .25s. But at 122bar, maybe 2 rotations of the hammer spring, 4 on wheel and I'm nearly silent at 891fps. Holding .5"@ 50m and about .7-1.2" @ 100

[@ScrotalsbySackington]

Hey buddy. Sounds like you're using way too much air. Way too much hammer spring. Should not sound like a loud pop and that's what I'm hearing. What pressure and how much hammer spring tension is on it ? What wheel setting?