Geeetech A10T modded printing ABS perfectly

I moved the electronics and Power supply outside the enclosure in order to protect it from the heat inside. I did very low effort (=none) cable managment that's why there is the towel. Don't forget to bring a towel, I guess :D I raised the enclosure and put cable below.
I use klipper and calibrated everything. this week I will add adxl345 sensor for input shaping and some other fancy stuff like herome direct drive printhead assembly which i am going to print with ABS. the led is controlled with klipper and I mainly use it to remotely check prints to turn on and off the light.
Also I am going to make good cable managment with a new housing for the Hardware as I don't plan to put electronics back inside. I want it to be a permanent high temp Material printer (ASA, etc.)

[@armorhide406]

I'm in the camp of Printing as my hobby and not the printer but hot damn does it always get me really interested