Genmitsu 4040 pro. Making a ring box in real time

[@kortt]

Nicely done!

[@Checkitfirst]

Thanks. I just wish I knew how to make videos lol.

[@FuzzyScaredyCat]

Thanks for this. This is the first video I've found that shows cutting speed in real time. What software did you use for the design?

[@Checkitfirst]

Thank you. I used CarveCo maker and UGS.

[@GpaL-ix7vl]

Great vid...what kind of wood are you cutting? 1/8" or 1/4" bit? Thanks 🙏

[@Checkitfirst]

1/8 bit. The wood was reclaimed from an old piece of furniture that we believe was cherry, but I am unable to confirm that 100%.

[@GpaL-ix7vl]

@@Checkitfirst Thanks 🙏

[@phillenburg2187]

What was your depth per pass?

[@Checkitfirst]

0.1” doc 72” /min Step over .0488”

[@phillenburg2187]

@@Checkitfirst nice! I need to just pull the trigger on one. Thanks

[@grandmastergeorgez]

Hi, why so slow?

[@Checkitfirst]

That’s as fast as it will go. I have it set to 100 inch/min. but it has that real soft takeoff and then a soft slow down and it just seems to run that way. I would assume there’s a G code somewhere that I can change, but I don’t know enough about it to make that happen.

[@Checkitfirst]

And I also believe that it comes out cleaner when you slow it down just a little bit but like I said, it’s fast as I’m able to get it to go on the day of this video

[@420247paul]

78 inches a minute is its top speed

[@incubatork]

@@Checkitfirst In UGS activate the Override buttons so you can speed things up, you will be able to override both feed and rapid speeds.