GHD Gold S7N261 Teardown for customers

Customers can purchase our repair service on the link below.
www.ghd-repair...
Spares for skilled customers or engineers are on the link below.
www.ghd-repair...
Ceramic plate repair is detailed on my engineers only forum. t-m-f.uk

[@DavidWatt]

Thanks for this. Had one with flashing red light and wouldn't heat up, after being dropped. Disassembled it to the thermal contacts. Fixed those us (they had bent away from the element). Out it back together and working again! I also hit each contact with a bit of solder too, as those wire grip contacts aren't the best.

[@mickwoodcock1323]

Great video. Thankyou! 10/10

[@ipaddleforyou]

Thanks for your great videos! If the GHD Gold S7N261 does everything as it did before (it bleats when plugged in, the power light goes on and off as it's supposed to) except now it does not heat up, what could be the fault?

[@wojtask1818]

Hello,thanks for nice videos. My wifi ghd gold just stopped working one day .Won't switch on like death. Fuse and cable checked.What else can I check? Regards, Wojciech

[@Trevs-Shed]

Hi Totally dead means the PCB has failed. You require a replacement PCB with matching elements. I offer this repair to UK customers but you will not be able to get the parts for a DIY repair.

[@docteurmo]

Hello ! Thank's for this video, it will be very useful 😉 I've a question, my ghd s7n261 make a red light when I turn it on, with piece I've to change ? And where is it ?

[@Trevs-Shed]

Sorry, but this model is not a DIY repair. Your fault could be broken wires, failed thermal fuse, cracked elements.

[@colinasdelcarmelo]

Good morning. Precisely my daughter asked me to check hers, because when you plug it in it beeps and the power button starts blinking while emitting the sound... what could it be? Thanks in advance.

[@Trevs-Shed]

www.ghd-repair.co.uk/guides/ghd_gold_and_max.html

[@donlucio1]

Is 540 Ohm correct value for thermistor and 39 Ohm acceptable for thermal fuse. Thanks for the answer.

[@Trevs-Shed]

Every thermistor is slightly different, the reading you have is normal. the element with thermal fuse measures around the figure you have.

[@donlucio1]

@@Trevs-Shed Thank You once again

[@shehnazjamal2950]

Should the plates make a rattle noise when rotating?

[@Trevs-Shed]

Not usually unless you have a very old and worn model. Certainly not on the GHD Gold this video was on.

[@shehnazjamal2950]

@@Trevs-Shed thanks for replying, this is a brand new model recently bought. Apparently the rattling is normal due to switch connection.

[@user-jl9hu2ik7b]

C3 какой конденсатор?

[@Trevs-Shed]

Если C3 считывает короткое замыкание, процессор PIC вышел из строя!

[@user-jl9hu2ik7b]

@@Trevs-Shed pic u3 правильно? наминал С3 пожалуйста, у меня он отгорел, а схемы не могу найти

[@Trevs-Shed]

@@user-jl9hu2ik7b C3 составляет около 130 микрофарад. питание 3 вольта. Around 130 micro farads. Voltage across it when active is 3 volts.