How to video on soldering technique for two lead through hole components that need to be replaced on a circuit board. This particular video uses a GM Delco factory stereo with burnt out light bulbs as an example.
Пікірлер: 8
@CrazyScaryHair10 жыл бұрын
Thanks for the info Gregg. Good video, but for me, very good info here in your comments. Saves me time of having to look them up.
@ivotenotocensorship52475 жыл бұрын
i can respect the struggle, this is how i used to do it too
@ve6wo10 жыл бұрын
You can also use PLT 7219 bulbs. They are 12 volt, T1 size. Long life (16,000 Hours).
@EP1CNELSON5 жыл бұрын
i like using the plunger or solder wick
@ve6wo10 жыл бұрын
Glad it was useful for you :-) It took a little while to find the right bulbs, so I figured I would share and perhaps save a few people the agony that I went through in locating them.
@ve6wo10 жыл бұрын
The light bulbs are available from www.1000bulbs.com . The smaller bulb is a T1 size, Eiko 2182. The larger bulb is a T1 1/4 size, Eiko 8640.
@GreenEggsSpam8 жыл бұрын
+Gregg Messenger Thanks for your help, Gregg. I used the 2162 bulb which is a T1-3/4 bulb for the LCD backlight and was able to get the white diffuser off of the old bulbs and onto the new, slightly larger ones. I didn't realize that a lot of places sell a 2182 bulb that is also a T1-3/4 size, so I ended up with 3 bulbs that are much too bag for the bottom row of buttons. Just cautioning others to read the specs carefully when ordering your bulbs!