GRS University: 105° Graver

Welcome to another season of GRS University, our weekly show where we show off tools, tips, and tricks of the trade.
Join Molly on this episode as she explains how to sharpen a 105-degree graver. This video is part three of a four-part series over graver sharpening.
If you have suggestions for future videos you would like to see, leave them in the comments below. We look forward to providing great free content and hope that you can find a takeaway from each video. Thanks for watching!

[@NoxiousWZRD]

Are there preferred degrees for the reshape given what task you’re doing?

[@douglasrandall6737]

How to line up the engraver in the holder?

[@Grstools]

If you are using a square stock graver (like what is shown in the video), make sure you place the graver in the QC holder so the set screw tightens down to one of the flat sides of the graver. You don't want to tighten the QC screw down on the edge of the graver, as that would have less contact between the graver and the holder. Also, when using multiple gravers, make sure the tab position of the QC holder is in a consistent relation to every graver. For instance, the tab might be face up when looking at the graver face. For some, the tab might be on the left when looking at their graver face. Keeping it consistent will prevent the need to adjust your handpiece every time you switch gravers. And a final note - once you place a graver in a QC tool holder, don't remove it for the life of the graver. Taking a graver out of the QC Holder after sharpening will require more time to resharpen it after placing it back in a QC holder.

[@Bushman42069]

this was honestly the most confusing part of the whole process.

[@ГошаГоша-ч8й]

Где купить

[@Grstools]

grs.com