Easily remove or install your GY6 clutch torque spring with this handy device from Scooter Doc Forum. For complete construction plans and instructions visit: SCOOTERDOC.PROBOARDS.COM
Пікірлер: 14
@DIOSpeedDemon10 жыл бұрын
Those Irwins are amazing. I use them at work all the time. I own a ZTR Clutch cage and it works wonders on all forms of spring loaded pulleys and clutches. Great video.
@thetajeff11 жыл бұрын
I would like to see a second video on how o replace the three clutch spread springs.
@MyIronman811 жыл бұрын
Its 4 wood claps bolted together people
@hichammoccie28099 жыл бұрын
hammer, screwdriver tap it few time's on side. Put 2 feet on the side's voila.
@vitali1st12 жыл бұрын
where can i get that tool?
@arvc291113 жыл бұрын
Where can I get this tool?
@thetajeff11 жыл бұрын
I like this video.
@TheHideandseek6913 жыл бұрын
where can i get the tool?
@paulocometti43172 жыл бұрын
I just used both feet ,,, just becarful....
@roberthuffman43549 жыл бұрын
VERY GOOD THINKING
@rexbrown81858 жыл бұрын
man i have a 2004 terminator 49cc. when i get to 20 mph it boggs down. whats happening with it?
@naps1saps7 жыл бұрын
I had a similar problem it was not getting enough gas. It had something to do with the auto enrichener. Replacing it did not fix the issue but letting it sit in the hole with out the screws fixed the problem. while reving on the center stand, spray carb cleaner in the carb when it starts to bog down, if that seems to make it better, it's probably not getting enough gas or the gas could be bad. drain the carb into a clear container and see if there is water in it.