H9 MB339 V2 K102 G5..SPEKTRUM SYNAPSE SETUP AND FLIGHT

[@n3cr0sc0pe]

Lovely review, great flight, thanks. The G5 starts are very impressive.

[@ModelAV8RChannel]

Great flight man! Good looking jet. Man the Synapse makes a world of difference.

[@hechtspeed]

@@ModelAV8RChannel thanks dude. Man. Youre not lying. The difference ut makes on the mb339 is kinda mind blowing

[@Hunterboy01]

We got this bulletin for G5 users, apparently it helps resolve the blowback issues during the critical start up phase. Another bulletin for G5 operations! Please consider install your engine +-1/2" closer into the pipe. This will prevent exhaust blow back from the bellmouth during critical phases of G5 quick start. The exhaust at this stage is highly combustible and often time resulting in damaged engine or burned up airplane. G5 rough and fail starts are often a result of the ingestion of this gas. Maybe worthwhile repositioning the engine.

[@hechtspeed]

@@Hunterboy01 yeah were gunna give it a try

[@Airsally]

Nice flight... that thing is so sweet.

[@JustwingitRC]

NICE! Great to see this one in the air my friend!!

[@andystoybox1723]

Nice flight !! 👍🏻 if you go to trim settings you can use 3 point trim on the throttle so you don’t have to hold the trim up or down so much .. 3 clicks up and it’s ready to start 3 clicks down and it will shut down ..

[@hechtspeed]

@@andystoybox1723 yeah i need to set that up

[@andystoybox1723]

@@hechtspeed 👍🏻👍🏻 you will like it 😊

[@CesarAgito]

Nice flight and landings were great! I am also setting up my 339 with the synapse but hoping it will work with my DX18v2.

[@MACE1-1]

Very nice. I would have liked to seen the touch and gos with the K85 also...

[@hechtspeed]

@@MACE1-1 i had a swiwin 80 in my v1. Ive got plenty of videos of that one on the channel :)

[@MACE1-1]

@@hechtspeed I'll watch some of the others again... Looks like it will be a good grass field performer also.

[@drmrjon]

I would like to build one with an EDF unit. Would you be so kind as to measure the rear exhaust outlet of the fuse. Everything hinges on if the outlet is big enough.

[@greatplanesman]

Looks like you need a bigger tail pipe, or a smaller turbine. If it sucks in too much smoke or can't push enough air out the pipe during startup it'll abort start.

[@hechtspeed]

@@greatplanesman i was the one who aborted the start. Sometimes it starts just fine. I dont think kt quite has the software for the start sequemce fully sorted out.

[@paulsexton8945]

Hi there does it need the carbon fibre satellites thanks

[@hechtspeed]

@@paulsexton8945 no im using standard rx satelites. Pretty sure its not actual carbon fibre

[@robskiba4163]

The carbon looking material is not CF. Regular satellites work just fine in this model.