Had to cancel my tuning appointment(ebay turbo problems)..

[@luiscamacho9220]

Mine was the same and i tuned it anyway. Still idles a bit rich in the 13s but runs fine. Good luck on your dyno session. Post a vid on the rollers.

[@civicpride1986]

Luis Camacho i sure will and thanks..

[@bseries8826]

Definitely want to see it on a Dyno. Yeee

[@civicpride1986]

B Series i do also, hopefully everything goes smooth and makes the 600whp.

[@LatinoAD]

Yup and I go with you haha to get it tuned. Months later my eBay gt3582 (6162) is still going papi lol on my b20b more than 3k miles and tons of races.

[@bseriesonlyhondasintegras1883]

Wow im glad i seen this video

[@bseries8826]

"Gotta pay to play." Well said.

[@Whoabolt]

Did you ever re do the oil drain

[@civicpride1986]

The oil drain was fine, the issue was the bad turbo... Replace it with a Garrett and no more issues.

[@fahadslife6561]

atleast, your not cheaping out on the turbo, should make decent power now, anyways you dont have to answer my questions but i recently got tuned and my wideband was properly working and i went to a car meet and i did some 2 step and all of the sudden my aem wideband is not reading no more( reading full lean - - - ), not sure if bad wiring but i doubt it, you think its the sensor? but if it is why? its brand new

[@civicpride1986]

Pipes Buds sounds like is the sensor in your case, you can test it.. remove it and place it on a rag full of fuel and see what readings you get, should read rich if it doesn't then the sensor is bad..

[@fahadslife6561]

its literally 2 days old, brand new aem wideband, if it is the sensor what could have cause this to happen?

[@civicpride1986]

Pipes Buds not sure if its only 2 days old then it was more then likely a bad sensor from the start.. test it and if its bad try to get a replacement should have warranty

[@fahadslife6561]

the thing is it was working properly fine until i did a 2 step and out of nowhere its reading completely lean all the time it will only change when i rev but goes back to lean ( - - - )

[@civicpride1986]

Pipes Buds 2 step will not cause your sensor to go bad, thats not it.. take it out and test it if it test bad then get a replacement..

[@fahadslife6561]

hows the tune? any videos?

[@civicpride1986]

Fahad's Life tune got postponed until this coming Saturday.. will keep you updated and will upload video.

[@SIRICKO]

How does your oil drainback, look cause i have had precision, and garrette, leak on me and it was my oil drainback was the problem.

[@civicpride1986]

SI RICKO oil drain back is perfect, the issue is thay damn turbo, has warranty so i am sending it back to rev9.. but i did noy want to run into any more issues so i went with a garrett.. gtw6262 at about 34psi should make more then my 600whp goal.

[@SIRICKO]

civicpride1986 can you make a video of it I’ll like to see it.

[@civicpride1986]

SI RICKO yea next time i make a video i will make one of how my oil drain set up is and i will drive car on highway speeds to show everyone how it drives.. btw whats up with your car did you ever figure that coolant problems?

[@SIRICKO]

Yeah the Air was doing around my radiator causing my rad to cool shitty. Over all i ended up rebuilding the entire engine cause my rings was also shot. Everything is on the channel.

[@civicpride1986]

SI RICKO i watch the rebuild.. but i was just wondering on your coolant issue.. good to hear is all good now.

[@TPSYKRT]

What restrictor are you using? Maybe you have too big of a restrictor

[@civicpride1986]

David Urrutia i try to different ones.. the first was .60 wich is perfect for journal bearing turbos and then i try a .30 and still leak oil..

[@TPSYKRT]

civicpride1986 how long have you ran the turbo? When I had my gt30 eBay turbo it did the same so I just drove it and it ended up just needed broken in

[@civicpride1986]

David Urrutia not long max 100 miles and i dont see all that oil it was leaking stoping, the exhaust was super wet on oil and so was my manifold when i remove it.. this turbo just sucks i guess.. some ebay brands are decent but this rev9 turbos are not.

[@cuongtran-ty1te]

GTW ARE CHEAP THO LOL

[@civicpride1986]

cuong tran same price as precision and more then turbonetics, i wont call them cheap but thats just me..

[@cuongtran-ty1te]

civicpride1986 I have the gtx35 gen 2 and the gtw 67mm its half the cost.

[@civicpride1986]

cuong tran not quite half the cost and one is ball bearing and one is not.. a ball bearing gtw is only slightly cheaper then a ball bearing gtx35.. regardless i just made 600+ on my gtw and i am happy.

[@cuongtran-ty1te]

civicpride1986 you're right the V band on the gtx35 g2 was another $400