Handbrake Adjustment - Peugeot 206

How to adjust the handbrake (parking brake) on a 2002 to 2009 Peugeot 206. Thanks for watching. Please comment, like and subscribe !.
All of my uploaded material is protected under copyright law. None of my videos may be re-uploaded, reproduced or transmitted, in part or in full, in any form or by any means, without the written permission of the copyright holder.
© / screwsnutsandbolts 2022
Read important information below:
Disclaimer
Under no circumstances will Screwsnutsandbolts be responsible or liable in any way for any content, including but not limited to, any errors or omissions in the content, or for any loss or damage of any kind incurred as a result of any content communicated in this video, whether by Screwsnutsandbolts or a third party. In no event shall Screwsnutsandbolts be liable for any special, indirect or consequential damages or any damages whatsoever resulting from loss of use, data or profits arising out of or in connection with the availability, use or performance of any information communicated in this video. Due to factors beyond the control of Screwsnutsandbolts, it cannot guarantee against improper use or unauthorized modifications of this information. Screwsnutsandbolts assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Screwsnutsandbolts recommends safe practices when performing any do it yourself repairs and or with tools seen or implied in this video. Due to factors beyond the control of Screwsnutsandbolts, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Screwsnutsandbolts.

[@markwilliams2830]

Good Info and detailed Video.Thanks for taking the time to make and upload.

[@screwsnutsandbolts]

Thank you :)

[@tompok76tompok76]

Thank you very much for your nice and instructive video :D

[@screwsnutsandbolts]

You are welcome!

[@tajwalikhan5082]

Thank You great illustration

[@screwsnutsandbolts]

You're welcome !

[@colinware4295]

Great demo,thanks a lot.

[@screwsnutsandbolts]

You're welcome !

[@Laura_r53]

Thanks bro just adjusted one at work since I had no idea how to do it hahaha

[@screwsnutsandbolts]

No problem 👍

[@Javier-m2z]

Gracias

[@andyg817]

If ones too slack somethings broken at the back or the cable has stretched...

[@jaymedemarco5794]

Muito bom obrigado pelo vídeo

[@screwsnutsandbolts]

Thanks for watching ! :)

[@romakayak]

Good video, thumbs up.

[@screwsnutsandbolts]

Thanks for watching !

[@alexharijanto780]

Thanks for sharing video

[@screwsnutsandbolts]

You're welcome !

[@zaxoromeos690]

Thanks a lot

[@screwsnutsandbolts]

You're welcome !

[@hipstarchild]

Nice. Thanks !

[@screwsnutsandbolts]

You're welcome

[@HouseJug]

Wow awesome video

[@screwsnutsandbolts]

Thank you !

[@guilhermeg345]

Hi, my 306 doesn't brake on a steep hill. When it went to MOT it barely passed with almost 30% difference. I tried adjusting on the drums to make them more even and then adjusted the handbrake cable so it gets hard with 5-6 clicks. It's still not braking. I have to pull very hard like 8 clicks and push the brake pedal hard too so it stops but sometimes it still doesn't work as the car creeps down.

[@screwsnutsandbolts]

Have the brake shoes been changed recently ?

[@guilhermeg345]

@screwsnutsandbolts the car was given to me recently and as far as it looks it's the originals from 99. I took the right drum off and it was all caked with brake dust and brake fluid, looks like it is leaking from the rubber boots at the cylinder. I spent all day adjusting them but I can't get it right. It feels like the adjuster is moving by itself every time I rotate the drum to check if it's too tight or not. I turn one time it's good, turn again it's loose, give some more clicks, it's good again, turn one more time it's too tight and it barely moves. When I finally got both around the same adjustment (slightly rubbing), I took the car for a ride and when coming, back the drums were very hot, lifted the car and the left wheel was locked and the right was hard to turn but it still turned. Adjusted again but it's going to happen again I bet. At least it's stopping at a steep hill now but I have to push very hard.

[@mihailiacob727]

Great detailed video! I have an issue of similar nature, the thing is that my right rear wheel doesn't brake similarly to the left and i'm not sure what exactly to adjust of where. Drums are pretty new for both wheels. Any ideas where should i check? Thanks

[@screwsnutsandbolts]

Have the brakes been bled ?

[@mihailiacob727]

@@screwsnutsandbolts Hi, not as far as i know. Will start with that

[@screwsnutsandbolts]

Is it just the handbrake that works differently on each side or the rear brakes themselves when you press the brake pedal ?

[@mihailiacob727]

​@@screwsnutsandbolts It's for both brakes. Right wheel keeps spinning until i press the pedal (or raise the handbrake) harder

[@screwsnutsandbolts]

Ah, that sounds like more of an issue that just bleeding the brakes. There could be a leaking brake cylinder which may have contaminated the shoes or something else. You'll really need to take the drum off and see what's going on in there.

[@jensnitsche4994]

Momentan genau gleiches Problem mit der Handbremse. Hervoragende Anleitung zum Überprüfen des Problems. Danke. Aber dieser Elektroblock unter der Abdeckung ? Ist das Fahrzeug nicht ein 206 cc? Schalter für öffnen des Verdecks ?

[@screwsnutsandbolts]

Thank you. I didn't know what that wiring block was, but this definitely wasn't a convertible 206cc 🙂

[@jensnitsche4994]

@@screwsnutsandbolts Thanks

[@antonioesteves6514]

I don’t know if you can help me, but for my Peugeot 306 when the rear left wheel is regulated correctly the right one locks way way more to the point Thant a can’t even turn it by hand when there’s no handbrake

[@screwsnutsandbolts]

Is the equaliser plate pulling the two cables evenly or does it look like it has to pull one more than the other ?

[@screwsnutsandbolts]

Are they drum or disc rear brakes by the way ?

[@nihonkokusai]

Does this work for brake discs 2003 without ABS?

[@toon9359]

Now you can do handbrake turns again

[@screwsnutsandbolts]

lol :)

[@Javier-m2z]

Un saludo

[@Gogata1964]

Здравейте! Бихте ли могли да направите клип за демонтаж / монтаж на предните седалки на PEUGEOT 206? Ще съм много благодарен!

[@screwsnutsandbolts]

I don't have the 206 any more, sorry !

[@emresertbas1173]

Please new video car soundproofing. My 206 is to many trim sould:)

[@laszlokozma6500]

👍

[@screwsnutsandbolts]

Cheers !

[@jukkakorpi2692]

Yuo have to do it inside of rear wheel!

[@morrisbuschmeier2047]

I use handbrake a lot, so I gotta adjust it. Shame on me.

[@2012lmfao]

2-3 clicks should hold the car.

[@phillipmoore4380]

The