Great review man, perfect to the point no bullshit. Every other review is 16 to 35 minutes. To much talk no action. Great tip on greasing o- rings. Learned that the hard way on a evo intake manifold what a bastard that was
@thangknowa3288 Жыл бұрын
From time to time, with all installed, run your finger around the bottom of the filter looking for oil seepage thru the filter media. May even drip along side of motor, exhaust, and right pants leg and boot. If so, remove air filter, wash and reoil, and repeat. When you tire of this process, install an "Oil Breather Bypass Can" to catch said droppings to eliminate mess and excess oil going into engine that fries and collects on top of piston.
@davidj.leavitt2495 жыл бұрын
Great video. Thank you. I just got the Arlen Ness Big Sucker Stage 1 kit for my 2015 Road King. Your video makes it easy.
@ljgaines81704 жыл бұрын
Very good video best one on the big sucker breather as a lot of your videos are cousin brother God bless you stay healthy and safe
@robertyoung56784 жыл бұрын
Is the arlen ness big sucker kit any better than the screaming eagle high flow kit ??
@stanleyhall7868 Жыл бұрын
No rubber vent tubes?
@ogmaddgroove798 ай бұрын
Did you have to take tank off to get the new bracket on.
@209er25 ай бұрын
No
@tylernelson19935 жыл бұрын
Why can I not pull the filter off to clean it? I removed the three hex bolts and ots just stuck there. I tried pulling it.. Floss.. WD-40.
@MrViolero6 жыл бұрын
I have a Dyna fdx 2008, where ddo I put the air flow sensor???
@sal85756 жыл бұрын
Do you need to do any fuel performance after adding this air filter?
@lovepreetmavi39156 жыл бұрын
Sal C yes FP3 is recommended
@An_Enraged_Pig6 жыл бұрын
Yes don't get the air intake without it
@An_Enraged_Pig6 жыл бұрын
I have an iron 883 2014. Do I have to install the two black rubber gaskets as well or just the aluminium one?
@estebanperez25574 жыл бұрын
Did you ever get that solved? I have a 15 fxd that has the same rubber hoses. Figured I didn't need them since the holes they attached to get plugged up with the bolts with the new kit
@1silvervespa2 жыл бұрын
Silicone Grease .....on the O-rings . Regular grease will shorten the life of them literally rotting them . No Vaseoline same problem . Petroleum based. Silicone is best.