Helical milling of worm

[@geardr158]

How would you divide for double and triple start without indexing plate

[@prashantpanchal9686]

You can index it using a job carrier against your jaw. Rest you job carrier against each jaw for indexing. Using a three jaw true chuck For production runs, you can outsource special cutters for two start or four starts.

[@geardr158]

@@prashantpanchal9686 great bt is there any possibilities for changing feed because there is only one step pulley was installed

[@prashantpanchal9686]

@@geardr158 In my setup, i dont change speed because i cut only one type of thread. However, you can always put a VFD on running motor for speed variation.

[@geardr158]

@@prashantpanchal9686 tanq so much,,such an useful information

[@maheshpanchal8820]

Prasant panchal Sir muje worm shaft and worm wheel ka module se OD aur uska center kaise nikale vo bathe sakte hai plz

[@OmPrakash-hh9zk]

Good

[@pig_74]

Вот вы упоролись, ребята!

[@SunilSingh-ed7ii]

Sir ye machine ke price kiya hai?

[@prashantpanchal9686]

It is a Pederson make universal milling I bought it for Rs. 2.8lacs used with a used indexing head. Cutter was purchased and reground for Rs. 18k. Motor and Gearbox setup cost about 16k. One control panel for starting the motor with overload relay and automatic stopping using a limit switch costed around 4k. You can add up the cost and do the math.

[@ImranShaikh-wp8hr]

Milling par worm or helical gear cutting formula btay sir

[@prashantpanchal9686]

Imran Shaikh Kitne module ka gear katna hai Kitne degree angle par?

[@ImranShaikh-wp8hr]

Me iti freshar hu nai jagah job lagi h wha bar bar puchhna prta he isliy formula or trick puchh rha tha me

[@narendralohar9912]

@@prashantpanchal9686 need your help... Pls give your mobile no.?

[@prashantpanchal9686]

@@narendralohar9912 9899262890