Hobbywing Slash 4x4 3S Test-Ovonic 7600mah LiPO

[@Kapap_Śpiący]

Hello did u have any problems with the esc or motor? and do you know how much waterproof is it? did u ride it through water or smth? thanks👍👍

[@FalconfireRC]

We did have an issue with the ESC cutting out, which we believe was caused by the connector. It was probably caused by the adapter we were using, but we replaced the XT60 with an EC5 and it hasn’t done that since. The only other problem was the stock fan dying, but that was our fault and not the fault of the system. Other than that, the system works great. I recommend it over any other 1/10 systems for a short course truck. It has never overheated (even running hard on 3S without an ESC fan) but you will want to run a heat sink & fan for the motor if you run 3S, just to be safe.

[@Kapap_Śpiący]

@@FalconfireRC Okay thank you for responding bc i was thinking abt buying it for my slash 2wd bc its brushed rn you know and upgrade would be cool. good to know that it is hard to overheat 👍👍

[@Kapap_Śpiący]

and last question did u take it underwater or in water ? you know i wanna know if its really waterproof bc i will probably ride it in snow a LOT

[@FalconfireRC]

Sorry for the late reply. We didn’t take it in water, but it’s been driven in puddles and in snow and we haven’t had any issues. So long as you put it under a fan every time you’re done driving it in the wet, the electronics should be fine. The bearings might rust though. Also, the fan isn’t waterproof. Just keep that in mind.

[@Kapap_Śpiący]

@@FalconfireRC okay thanks 👍👍

[@larvanen902]

w vid i want an traxxas rustler i dont have money :(

[@FalconfireRC]

Do you have a job? It only took me a few months after getting a job to save up for my Traxxas Hoss.