Making a rifled barrel from a Grade 8 bolt. 9x19 9mm Luger
Пікірлер: 14
@nathanbodey876523 күн бұрын
Great work, love the ingenuity! Question though? By having the rifling on the bit and with you pushing it in, is that just spiraling on its own?
@ottowhack924823 күн бұрын
Yes it is.
@NextWorldAssociation19622 ай бұрын
That looks nice
@Millanm.236Ай бұрын
Que brocas utilizaste para hacer el cañon, de que medidas ? Osea de cuentos milímetros? 😊
@Sagitario232 ай бұрын
Exelente ¡ de Argentina . Cuantos grados la fresa...
@ottowhack92482 ай бұрын
1 rotación en 10 pulgadas.
@Cyberpunk_BansheeАй бұрын
What steel was the rifling button made from?
@ottowhack9248Ай бұрын
It was cut from a injection molding machine ejector pin. The rods I used to push it through are also ejector pins of a smaller diameter.
@theshadow533729 күн бұрын
Nada mal para algo casero
@leventecsonka8747 күн бұрын
Hi! Could I ask what is the diameter of the rifling button that you made ? How deep is the groove? Thanks
@ottowhack92484 күн бұрын
Before I started with the grooves I ground each end down to a size that was a sliding fit in the bore (shown at 0:56). I used those ground ends as a guide to know how deep to make the grooves. Better if they are deeper than needed than not deep enough. The button was made from a 9.5mm (.375") ejector pin. This is oversized. I didn't show it in the video but after making the grooves I ground it to a slightly smaller diameter.
@leventecsonka8744 күн бұрын
@@ottowhack9248 Thanks for the info!
@RabiehRabieh-qi7ff12 күн бұрын
It is very wrong to use this type of barrel because it must be 4041 steel, which is less ductile