Honda GC190 Carburetor Clean - Won't Start?

Due to factors beyond the control of Hank's Garage, I cannot guarantee against improper use or unauthorized modifications of this information. Hank's Garage assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Hank's Garage recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Hank's Garage, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Hank's Garage.

[@9mmTXn]

I had a stuck emulsion tube as well. Put the carb in my Hornady ultrasonic cleaner with some simple green for a cycle. Followed up with some carb cleaner, then put the jet back in and applied a little torque. Removed the jet, and the emulsion tube broke free super easy.

[@mitchrenee]

Thanks great video

[@brianking1138]

I can usually get the emulsion tube out by pressing from the top with an Allen wrench. Sometimes they won't budge.Don't forget the pilot jet under the plastic cap.

[@lawrencecarroll2031]

I use 6m threaded rod to make disassembly and reassembly easier on that carb. Take one of the bolts out, thread rod in, take the other bolt out, thread 2nd 6m rod in. You can leave them in if you want and just secure carb with 6m nuts or remove them one at a time and reinsert long bolts. Good video

[@Rustycam1025]

Yessir! I do that as well. Makes it so much easier to slide all the various gaskets and spacers on there one at a time.Everything stays in place.

[@Bobcagon]

Ya I saw some dude doing that on a Honda vertical and thought what a great trick. This guy makes it look not too bad but anyone who has worked one of these knows better.

[@Bobcagon]

Anyone know the pre symptoms of the fuel going on these? Or does it just quit….then nothing?

[@SwimFlySwim]

I had my carb cleaned, ran when I got it back from shop. Ran it. Ran it completely dry as we’ve had problems in past with stale fuel. Filled it with new fuel today and the f’ing thing again will not start. I’m about to just give up on it. Spends more time in shop than in use.

[@velbarker6203]

Не стабильные обороты на данном двигателе что посоветуете?

[@joblessalex]

Fuel pump on a carbd motor? Wtf?

[@hanksgarage_]

YUP!

[@queenstownkid]

i dont like that carb setup