How I Assemble Flexcable & Prop Shaft Without Solder - RC Boat Build

[@shanewilliams2922]

Hope you feel better soon !!!!keep ripping it up !!!!

[@bladesofthunder9778]

could you drill a hole and pin with a steel pin for extra security?

[@IRONCLADRC]

I guess you could but it's really not needed, as long as you properly prepare the connection it should hold. Filling a hole through the flex cable may weaken the cable

[@RC-gj7kq]

Really nice video. Thanks for share.

[@johnnymcclurg9672]

On big rc boat builds use shaft out of an old weed eater.... try it

[@RC-gj7kq]

Hi. How u can separate flex shaft for strong part of shaft? With hot?

[@im2tall1]

Get some rest! We'll be here!!

[@pavelack]

The JB weld flex shaft on my SR80 pro is still holding tight! Ive upgraded to a sonicwake and got some upgrades coming, the snow is here though now so itll be a shelf queen until nenxt season

[@Everythingthatgoes]

I was thinking about using jb weld because I’m tired of losing props. Great video man 👍

[@IRONCLADRC]

It works. Prepping the shaft and flex is the most important part.

[@AGRspeedlab]

@@IRONCLADRC This blew my mind.

[@edwincordero8]

Ok. Good job. But where can I find the hollow shaft and it's part number for a .187 flex cable?

[@IRONCLADRC]

I didn't see any .187 bore shafts either if I find one I will post the link.

[@vadimkvak1751]

Have you try loctite 603, 638 or 648? 603 is oil resistant but 648 is the strongest of them

[@IRONCLADRC]

I think 603 is recommended for the flex/stub joint! Same methods different Adhesive

[@williamwise3050]

I hope you all are filling better now!!!!

[@IRONCLADRC]

I'm actually Justice starting to feel the effects, I've been OK'ish until this morning. Hopefully it will pass. I'm IRONCLADED OUT. 😆

[@vadimkvak1751]

@@IRONCLADRC take care Man! We need you healthy;)

[@rodneyrasmussen1199]

Hope the you and your family are doing better Big B

[@IRONCLADRC]

They seem to be doing better I'm just starting to feel the effects. I'm ironcladed out! So I will up and at it in no time! Haha. Thanks buddy

[@johnnymcclurg9672]

If you know how to use JB weld that shit is amazing i put a engine case back together on a motorcycle that threw a rod busted the engine case at the seam I put the two halves back together better than factory I think