How I installed CH750 CRUZER Nose wheel and Doors Jul 20

[@generalcanby5847]

Fantastic video, Scott. Thank you for taking the time to illustrate and explain things so well.

[@flyingscotsman5032]

The Build is looking great, also fantastic video once again. Please keep them coming! Cheers from NZ

[@scottmatthews5280]

Flying Scotsman thank you.

[@davidsmeaton3082]

Great progress, really enjoying the videos

[@anthonyamadio1998]

Hi Rowdy great job mate really enjoying the build

[@scottmatthews5280]

Thank you

[@gregbevpriest7623]

Engine at a guess will be a Jabiru Gen 4 based on Scott's current airplane love, cost and being Australian built.....lets see if I'm right ...LOL

[@littlewingpsc27]

Great progress Scott. The bottom hatch mod was done really nicely. Will you add some sort of thin flexible gasket to the access cover to keep the exhaust fumes out?

[@gregbevpriest7623]

Nose wheel...Scott the Pre load on the rubber doe nuts should be approx 1/4" or 6mm

[@nottelling1382]

Fold the top skin up then tape it it will stay put with out damage

[@johnfisk4666]

I'm enjoying your videos I'm not too far behind your progress. What engine are you going to install?

[@scottmatthews5280]

All will be revealed when the delivery truck arrives cheers.

[@Laserdoc905]

Thanks for the update!! Do you happen to have the part number for the swivel plates. Looks like a great idea. Thanks Sean

[@scottmatthews5280]

This will get you close www.skytekaircraft.ca/aircraft-selection.html.