How it Works: Hydraulic Throwout Bearing - Mantic Clutch USA

[@loficanvas-rx5et]

2:22 what do you mean push this off the end and it’s going to leak and you have to do it all over again? Does that mean if it’s not correct at first then you have to buy a new CSC?

[@mikeskidmore6754]

If the Throw out bearing is touching the clutch fingers while the clutch is fully engaged, that throw out bearing is not going to last very long. The Silver Metal part is the Bearing .. The Green boot that has a spring inside, I would assume also has a slave cylinder inside the rubber boot. The whole thing is not a bearing.. It's a slave Cylinder and clutch throw out bearing assembly .

[@SuperLATINMIX]

took me like 5 months to find this vid

[@mikeskidmore6754]

OK so I was totally wrong .. I have set up many manual clutch linkage throw out bearings and you don't want them toughing the clutch fingers while the clutch is fully engaged.

[@muckman5509]

Do you grease the input shaft before you fit the bearing over the shaft ? Or does the input shaft never touch the bearing sleeve ?

[@JJ-zm7kj]

Hello, What effect the clutch pedal force? pressure plate spring or Clutch Master Cylinder or Slave Cylinder?

[@davidgruen7423]

Why does some installation warns not to push bearing prior to installation, what damage can it cause? Also can pulling vacuum from the master cylinder reservoir cause the bearing to retract and cause damage?

[@Krankie_V]

It still seems weird to me that the throw out bearing is always pressed against the pressure plate fingers even when fully disengaged. I just replaced the clutch in my F-150 and the whole concept seemed so wrong

[@playmaker7094]

😂😂I am also struggling to understand why,it is engaged when the clutch is disengaged

[@Krankie_V]

@@playmaker7094 I reckon it's the only way they can make the pedal feel right.

[@playmaker7094]

@@Krankie_V yeah,I agree

[@davidblalock9945]

I can't hear anything, and my system volume is at 100%, so is the player volume.