How to adjust 03-06 GM truck gauge cluster needles

This is trial and error you will have to keep adjusting it until it falls on zero.

[@chadscheller6051]

After replacing the bulbs in my instrument panel,I have been watching video after video, trying to get the needles to sit properly. I've had no luck, until I happened to come across your video. What you showed finally worked. Thank you for taking the time to post it.

[@loudiemonz]

How did you get the other needles set? All mines are a little off now after repair?

[@alexzuniga2933]

Ok video I been researching this for when I have to change my bulbs and adjust the needles so far there’s not many good videos explaining this well. Will try your method when I do my cluster repair.

[@Noah-nc5ey]

0:47

[@elstaticduran1557]

How can you fix the others gas,oil,temp,rpms ??

[@ainstaink8312]

Same way! When power is applied to the cluster they should recalibrate at 0! All of them! Remember NO ignition!

[@alexxdoesit5.314]

Hello video is great! How did you get the corvette emblem in the middle of the steering wheel??

[@olegyak3539]

The airbag cover is from a trailblazer or envoy and I had the emblem made to fit in place of the Chevy emblem

[@owa2533]

Where did you get that overlay?

[@ainstaink8312]

You are technically correct, but I would not force to move that needle the way you did. I remove them using fork and then just lighly insert it, and once you get to the right point push it in.

[@marianomendoza8414]

Have you tried removing the blue paint that the cluster has behind the numbers ?

[@olegyak3539]

@@marianomendoza8414 if you are careful you can sand off the blue film

[@Ugybug1900]

@@marianomendoza8414 you can buy replacement overlays at carradiobulbs.com that dont have the blue film

[@sebastiansirias541]

I Repair a Mercedes Benz Cluster with this method!...100% positive!!! Thanks!

[@tudeddy7026]

@@olegyak3539would you sand them from the back of the cluster face? Or the front?