How to Bind M1 and M2 helicopters with RadioMaster Transmitters

This video is a great tool for learning how to bind your M2 EVO and M1 EVO with any RadioMaster controller from the TX16s to the Zorro.
Check out our store here!
www.buddyrc.co...

[@cbezanis]

These how-to videos are putting Buddy RC a cut above the competition !

[@MLeditsofficial]

Bro can I just bind the heli and fly without doing any configuration or any curves

[@theviperman3]

Is there any video tutorial showing complete setup of the M1 on the Radiomaster 16x (channels, curves, idle up, etc)?

[@alvintarrer6914]

Thank you brother Clay, it's appreciated 👍🇺🇸🇨🇱👊

[@glenduncan8125]

Another great how to video Clay.😃

[@TruckingWithSteffon]

OUTSTANDING!!!!

[@crab445Hornet]

Great video mate explaining all that ,,just wondering if you have a video on radio master Zorro how to program pitch curves / throttle curves ? My M2 Evo only just gets off the ground on Idol up normal mode ?? Thanks i’m just a Newby and there’s not much on Zorro programming out there also I’m running the Futaba satellite on heli 👍👍thanks....

[@BuddyRC]

Thanks for watching! My throttle curves will be different but I don't run a normal mode so my throttle curves are all flat. As far as the pitch it should be a -100 to 100. Also try to dial in the pitch with the pitch setting on the flight controller you can add and subtract pitch by using your elevator stick.

[@InterceptorKZ]

How make a setup heli with Pocket transmitter?

[@BuddyRC]

Thanks for watching! There should be a program already in the pocket when you buy it.

[@blooskyy7]

Is it possible to use an ELRS RX with the M2?

[@BuddyRC]

Thanks for watching! Yes you can you just need to run it as a sbus receiver and get a plug from one of the Sfhss receivers so you can plug into that slot on the flight controller.

[@blooskyy7]

@@BuddyRC amazing, thanks