How to clenup EGR/AGR valve (ventil) - Opel Vectra C - diesel 2.2 DTI 92kW, Saab 2.2Tid (125hp)

How to clenup EGR/AGR valve (ventil) in Opel Vectra C, diesel engine, 2.2 DTI 92kW (125hp), Saab 2.2Tid, 2002-2004.
More at: en.wikipedia.o...
or autobible.euro...
ADAC: www.adac.de/ru...

[@Galdnieks]

Thank you a lot. This really helped me, i couldn't get the egr off, but opened the intake and cleaned from the top. Car is working again and will work, till i have the time to swap the valve.

[@VladDublin]

Your welcome, as they say in Tesco "every little helps" :-)

[@erollkrasniqi5947]

Bro thank you so much, i've been searching for a video that shows in details. Much love🖤

[@krzysztofkrafczyk8939]

I recommend to take off that plastic cover on top of valve ( right on the corner ) then clean and grease sliding parts ;)

[@andregaspar9669]

Thank you! This is video is perfect! 💯

[@VladDublin]

Your welcome :-)

[@miroslavcharvat2220]

Počítejte s tím, že pokud je egr opravdu "připečený", ven se mu nebude chtít, demontáž může zabrat až hodinu a může se ulomit i trubička od vody. Doporučuji zkontrolovat i klapku, která je v potrubí nad EGR ventilem. (Pokud se kousl ventil, klapka bude taky) jinak video 👍

[@southendparaquest]

Could you modify the title/tagline to include Saab 2.2Tid if possible? They're identical, but there's hardly anything on the Saab.

[@VladDublin]

Thanks, I didn't know about that. I put Saab to the title. Maybe will help to other people. Thank you pal.

[@mostbrutalvideos4612]

Same engine as my 2005 SAAB 9-5 linear 2.2l TID diesel

[@MrChmielu11]

what tool should i use to remove these screws?

[@josetrigueiro5978]

It's a female Torx (star) drive. I don't know the size.

[@vedi.I_123]

poz ,dali se moze blokirati egr u opel vectre c.

[@recall2880]

Just tried for ages. Almost like it’s been welded on

[@oleksandrdemchyshyn2452]

Thank u. But that is only half of job. You better clean axle as well.

[@gadgadenush9711]

what was washed? can you be more specific?

[@VladDublin]

It was a special fluid for washing egr valves. Something like this one: www.mroauto.cz/cs/katalog/detail-zbozi/prostredek-pro-rychle-cisteni/amtra/20-a22/1300580?gclid=Cj0KCQjw5ZSWBhCVARIsALERCvxZVsa7DrzurH_ijRBZiIcaHtQZ1hFR72yBUNb0_G3jzX03wJmfYEsaArmmEALw_wcB

[@andreabivona6853]

Ich habe es auch gemacht und meine auto springt nicht mehr an hilfe

[@VladDublin]

Also weiß ich es nicht, überprüfen Sie vielleicht die elektrischen Anschlüsse, Sicherungen und welche Fehler von der Selbstdiagnose usw. Es tut mir leid, dass Ihr Auto angehört wurde. (So I don't know, maybe check the electrical connectors, fuses and what errors are reported by the self-diagnostics, etc. I'm sorry to hear that your car stopped starting.)

[@KokusLV]

Do i have to clean inside hole aswell or leave as it is?

[@VladDublin]

It is depend how does it look inside, if is dirty, use clean cloth and make the hole clean, maybe use some chemical, it is prevention. Good luck :-)

[@KokusLV]

@@VladDublin Ok, thanks!

[@mostbrutalvideos4612]

I hate those clips I’m having to replace them with jubilee clips to make life easier

[@recall2880]

I undid the bolts but it won’t come off any ideas?

[@VladDublin]

Try to use screwdriver and hammer, just be careful.

[@recall2880]

@@VladDublin I did it. The best way was not to use a screwdriver to tap it. Very easily broken. Just spray some lube and keep rotating left right whilst pulling gently. Tapping on it will break it.

[@yabadabado7414]

Mine stuck aswell. Did you end up getting it out ? Iv got mine working again using a egr spray down the air intake but would still like to remove for a deep clean. Thanks in advance

[@recall2880]

@@yabadabado7414 Yes I did. Do not pry it apart and ruin it all like I did. Just put your hands round the whole thing with gloves on whilst wiggling it back and forth like a good un. It will eventually work itself free

[@recall2880]

@@yabadabado7414 Lots of wd40 too whilst doing it.

[@romankulich6150]

Ahoj