How To Factory Reset Lutron Radio Ra2 6 Button Keypad To Default

In this video I will show you how to Factory reset your Lutron RadioRa 2 Keypad to default.
1. Triple tap and hold any button* on the device.
DO NOT release the button after the third tap.
2. Keep the button pressed on the third tap until...
A. Dimmer: the Dimmer LEDs ramp up and down
rapidly and the load flashes at the same rate.
B. Pico ® Wireless Control: 6 to 8 seconds.
C. All other devices: the LED(s) start to rapid-flash
(approximately 3 seconds).
3. Release the button and immediately (within
1/2 second) triple tap it again. Dimmers and
Switches will normal-flash their loads. All other
devices will rapid-flash their LED(s) again. When
the load(s)/LED(s) stop flashing, the device has
been reset to factory settings
Please don't forget to Subscribe, Thank you!
VPN Specials
Surfshark: get.surfshark.net/SHwn

[@willienewelljr388]

How to wire it

[@JasonReset]

Same as a switch or a dimmer. But you need the lutron software to program it.