How to fix Electrolux dishwasher with lights flashing i30

Pressure switch kit #5304504077
Electrolux dishwasher lights flashing and keeps draining
Please follow me on Facebook .
www.facebook.c...

[@chui8619]

Thanks

[@hameedwafaAFG]

You are very welcome!

[@Potsnu]

Thank you so much for this video. I think you'll get more views if you put I30 error on the title. None of the other videos were as good as yours.

[@hameedwafaAFG]

@@Potsnu just did it . Thank you so much for sharing your thoughts 😁

[@valentynshyshkin3513]

Hameed you are the best!!!!

[@hameedwafaAFG]

You guys are awesome 👏 Thank you 😊

[@jeanineadams-palmer7422]

You ROCK !! Thanks for all good information

[@hameedwafaAFG]

Yeh

[@SSTW]

That's why you are my guy!

[@hameedwafaAFG]

Thank you ! Really appreciate it likewise !!

[@natigaghayev6190]

Thank you!

[@hameedwafaAFG]

My pleasure!

[@eganix]

My base was dry, I replaced the pressure switch and I still get an i30 fault and pump continues to run. Any ideas? Thanks.

[@hameedwafaAFG]

@@eganix probably bad main board if the pump keeps running also there is a switch under the float styrofoam maybe that switch is burnt and it keeps sending wrong signal to control board

[@eganix]

@@hameedwafaAFG Thank you. Do you have any idea what part number or what the part looks like? Ideally I dont have to replace the control board as they are very expensive.

[@jamesdean5677]

Hi, my Model ei24id50qs0a dishwasher is dead. It doesn't matter if I reset the breaker. Air dryer light flashes along with random led segments. I was on vacation and came back to find the tub full and this display. I used the wet vac to remove all of the water and left power off for 24 hours but it is still acting the same. Here is a video of what I am seeing. kzbin.info/www/bejne/kKfWdaB8l8yela8 Thanks.

[@hameedwafaAFG]

I saw your video , there is probably water under the dishwasher still , causing it to blink like that . I would say run a fan in front of it for 24 hours and see what happens .

[@hameedwafaAFG]

I have also seen similar problem with display board or loose connection loose wire under the door .

[@jamesdean5677]

@@hameedwafaAFG Thanks for that! There was not even one drop of water under the dishwasher though. Still run a fan at it you think? I was once a bench tech so not afraid to mess with the display a little. I think it might be more sinister than that though. Since owning this thing, it randomly developed an issue where it would sit at 1 minute for hours on end and never drain or shutoff which is particularly threatening for my well pump if forgotten let alone the dishwasher. I would clean things up and it would stop doing that for a few months then come back. It started acting like this then we went on vacation. We had our adult son instructions not to turn it on at night and forget it. I think he meant well and turned it on during the day where it probably died at some point resulting in the more difficult scenarios you mentioned. Thoughts? Thanks again man.

[@hameedwafaAFG]

If you pulled the dishwasher out and lift up the insulation from left side and did not see any water under the dishwasher by the main sump , you don’t have to run the fan for 24 hours , check for broken wire under the door , but for finding the broken wire you need to take the front panel off , worse case it could be the display board . I may have a new one in stock if you need it , I can ship it to Canada locations .

[@jamesdean5677]

@@hameedwafaAFG Thank you! Will let you know. Appreciated.