How To Increase The Flow Rate On A Bakki Shower. How To Change A Pressure Filter & A Variflow Pump

[@carollycett1329]

Nice update on the filter change stay safe

[@AKoiEnthusiast]

Cheers

[@keepingitkoi]

Great update bud 👍

[@AKoiEnthusiast]

Cheers for watching

[@praiseworthy]

Good job

[@AKoiEnthusiast]

Thanks

[@paulthompson6975]

Thanks for showing how to increase efficiency and save money at the same time. Where did you buy your flow meter from?

[@AKoiEnthusiast]

Cheers for watching. The Flow Meter was off a selling site. If you search you might find it on Amazon or E Bay. Just make sure the size and range is correct for your use

[@praiseworthy]

Thank you for the video. Very interesting I was looking for a similar video I have bought Bakki shower, and I am on the way to precious drum filter compact M, from oases but that I was not going to connect the bakki shower with sprinclean i was going to connect only directly with a pump 15 to 20 k and not use any spin clean 30000 Is that possible?

[@AKoiEnthusiast]

Thanks for watching. Having the Springclean fitted means I have never had to disassemble or clean my Bakki Shower. You definitely need some sort of pre filter (That doesn't reduce the flow too much) other wise the Bakki will block up with fines

[@steventhompson6180]

Are the koi still available and what is the best way to pass on our details 🤔

[@AKoiEnthusiast]

The Koi in the large 17,000 gallon Pond were snapped up last week and are now relocated. Some of the equipment may still available but the guy's details are in the Details and Comments of the Video if you want to speak with him. I have a load to rehome very shortly from both ponds if they are any good. There are about 55 1 year olds from 8" to 12" and a couple of 2/3 year olds from the Main pond between 12" and 18"

[@JGlover123]

Hi any tips on error 88? Just finished my pond and can’t get rid of it! Played with the flows for ages and adjusting the levels and floats as per the manual

[@AKoiEnthusiast]

Cheers for watching. I had that issue once. It is for Gravity Fed systems and refers to the Pump status detection being incorrectly set. (Set parameter for pump status detection to 0 (→ E7: Pump status detection) The little black conical shaped float. Sometimes it gets stuck or the plate holding it bends down when opening the lid. Give it a clean and make sure it is square and secure

[@JGlover123]

@@AKoiEnthusiast hi, sorry, I’ve sorted it but thankyou very much for the comment. I did exactly what you just said and it’s now gone! Just another question, where the water level is inside the filter where you have min & max lines. Ideally the water needs to be in between them 2 lines. Mines on around maximum so it’s ok. But when I switch the pumps on, it drops below minimum. I have an auto top up trickling in but it won’t rise until I turn everything off again. Is this how it should be? Thanks