How to Install everydrop® Water and Ice Filter 2 EDR2RXD1

How to install or replace everydrop® Filter 2 (EDR2RXD1) for 6 months of clean, fresh tasting water.
Find the correct filter for your refrigerator at everydropwater.com.
The filter compartment for everydrop® Filter 2 is located in the upper right side of the refrigerator ceiling. Push up to open the filter door; twist counterclockwise to remove the old filter. Remove the cap from the new filter, align it with the notch in the compartment, push in and turn clockwise. Push up again to close the filter door. Flush the dispenser and you'll be ready for 6 more months of clean, fresh tasting ice and water.
The only water and ice filter approved for Whirlpool®, Maytag®, Amana®, KitchenAid® and JennAir® refrigerators.*
*EveryDrop® products and the recommending brands' products are all owned and distributed by Whirlpool Corporation.

[@ashtlaird]

You forgot an entire step. After you replace the water filter as shown, you have to open the left door of the fridge and on the side panel of the door, simultaneously press Max Ice and Max Cold in order to Reset the water dispenser, otherwise the water dispenser will still show “Replace”.

[@pydron]

Is there any way that you can get a replacement "bottom cap"?

[@cecipala1]

My filter is stocked how can I get it out??

[@mueidkhan19]

Where do I get the “bottom cap”?

[@angieprangie]

How much water do you run after you replace the filter before you can start drinking the water again?

[@kelseychantel2357]

3 gallons or 12 litres. Just had to look up the same thing 😂

[@user-pw9ni8ez9p]

This is no help at all. The old filter will not turn to the left and there's no handle on it either so it's just stuck there. It's also located on the ceiling of the fridge, not the bottom like in this useless video.