How to install QL-38 Hood Pins on your S550 mustang

[@deanojet2991]

Good video! I'm gonna be doing this on my Cobra R cowl hood and I think I'm experiencing anxiety for the 1st time ever😂

[@rubyfast4527]

Way cool. I started the process using their directions and thought to myself, I think I know a better way. Think I'll try and find this guy online on KZbin. This was it. Man, they just wanted a 7/16 hole and then hole saw. You would have to large of a pilot hole for the Hole Saw. Glad I watch and did not drill anything but a small pilot hole in the bottom.

[@AtticAZ]

Love your pin placement vs where most put them. I have the Cervinis Stalker hood coming... I'll be installing these.

[@green3488]

I'm getting the Stalker X carbon fiber version.

[@45snakebite]

Bro, Safety Glasses. Thanks for the vid.

[@johnterpack3940]

First video I've seen that did it right. Others drilled the pilot hole all the way through at the first mark.

[@Car_nage]

What size is that hood pin ? 1.75 ? 2.44?

[@s550depack4]

@@Car_nage 1.75

[@lawrencecarter292]

Looking to do it on a Ford F-150 Harley Davidson 2003 GT500 hood thanks for the video.

[@Girzir]

does this fit a 2022 ecoboost mustang

[@s550depack4]

@@Girzir this process is universal, you can use the same location or pick a different one but the process is the same

[@gabrielromaguera494]

Are these the low profile ones?

[@BMWE30S54]

The safety squints working hard at the beginning of the video 😂. Wear some safety glasses people

[@s550depack4]

@@BMWE30S54 safety squints are OSHA approved

[@ericlira806]

Did you keep the hood latch? I'm trying to decide on these and the aerolatch hood latches

[@s550depack4]

Yes keep the hood latch, when you go to pop the hood, pull the lever in the car then press on the pins

[@ericlira806]

@S550 DePack sweet, I wasn't sure if the buttons disengage first or pop the hood first then pop the quiklatches. I need to do mine so they don't flag me at the track

[@Ricky_Rocha]

Do you know if it’s the same process for the QL50?

[@s550depack4]

I would say you can use a similar process

[@Ricky_Rocha]

@@s550depack4 Thanks for the reply. Do you know the difference between the one that you installed vs the QL50? Also I think for mine I would have to use a 1 1/2 size

[@s550depack4]

I do not know the differences but the QL-38 is smaller. Just use a hole saw smaller than the top cap and follow a similar process

[@Ricky_Rocha]

@@s550depack4 thank you bro

[@MaxJam684]

Roasted that jagged hole! Use cutting oil, and hold that drill vertical.

[@Smasher-Devourer]

Whole lotta NOPE