How to install RAM hydraulic release bearing

[@downlowperformanceinc4860]

finally a good piece of instruction. the printed copy I got with mine totally useless.

[@wtfobiden]

Time to order my parts from RAM

[@md-run]

Probably the hardest way of measuring, your better bolting bellhousing, clutch and flywheel to engine then then measure

[@realdeathpony]

Same. Do an A-B measurement

[@thechestnutking736]

Exactly

[@jagco2594]

What is you have stock type bellhouse. And 1.7 / 1"/34 co-laps is to big tall. And needs to be shorter 1.5" or little shorter. chevy 350 1st gen.

[@thechestnutking736]

I’m just blowed away by Ram clutches lol. Sent me their HD clutch good for 600 HP but the pressure plate was junk. It was the same pressure plate used for like a 4.0 Jeep. I’m serious, you can’t make this shit up.

[@JohnSmith-qj4cf]

Have a AR5 transmission fobbot adapter 4l60 bellhousing Ls can you help with this throw out bearing thks

[@davidhamilton9902]

Why are you using white instead of yellow thread tape

[@Mazda62626]

Questions about the stud length. If the bearing is all the way retracted won't it hit the fingers of the clutch? I am going to be installing this on my 2010 Challenger in a week and I want to do it right.

[@iammee1111]

Really? You set it so it's about .200" before it touches them. Clear as mud

[@markmcdowell2774]

Bearing moves 495 thousands only, is that enough?

[@3literheater]

You put the tape on backwards

[@pete540Z]

I didn't look closely the first time I watched, but I agree! The tape is wrapped on all 3 fittings in the incorrect direction, and it makes a difference.

[@filthbomb]

chinese fittings ? ........boooooo.....