How to Install the Hive Thermostat Mini on a Traditional Heating System, Step by Step Instructions.

[@madmaycon2531]

Perfect !!!! Thank you very much for your videos, they are so good and helps a lot especially for new qualified gas engineers like me.

[@tauqiranjum1434]

I really like your videos . Very helpful Could u plz do all this procedure with one thing connected. Then it’s easy to learn the wiring

[@TheScottelias]

Thanks for the vid. Is the wiring the same for a thermal store?

[@RayMurtagh]

Hi, I have just purchased and fitted a dual channel HIVE system for my oil fired central heating and it is almost working 100%....but there was no wire behind my old analogue Honeywell controller for water....just 3 wires...L N and the common for live transfer so in effect if I hit the hot water option it just comes on at the switch as I can't heat water separately and never could unless it was the immersion in the hot press. Does this system require additional wiring to the receiver to turn on the immersion? Otherwise am I right in saying that the water option only is redundant? Hope all that makes sense. So when I turn on the heating the oil burner fires up outside and heats both radiators and water simultaneously but I just don’t see anyway of heating water separately with only 3 wires at the controller. Any advice appreciated. Thanks in advance.

[@danielwilliams-pp6wl]

Hello, are these modulating heating controls

[@gamereva6413]

Great video, as usual. Is there a part number for this, just to make sure I get the right one. Thanks.

[@PhilipGreenway]

I have miGenie currently - works perfectly - oil boiler - 3 heating zones wireless thermostats plus wired hot water stat on tank - how do I wire in Hive 2 channel(CH1 +HW) and two extra Hive 1 channels (for CH2 and 3) ? Many thanks, Philip

[@vicramsingh2330]

👍👍