How to Installing Ruxifey Mirror Switchback Lights On My Ford F-150

[@Julio-bc7pj]

thx man, are they still working fine?

[@BiggsWrld]

I sold the truck but yes!

[@Julio-bc7pj]

@@BiggsWrld thx man, yeah i noticed it on your latest videos. Best of wishes on the new vehicle :)

[@jamesnapper716]

Could you also show how you ran the wire from the mirror to the inside of the cab to the connector from both sides?

[@BiggsWrld]

I think I am going to make a full part 2 video

[@tyrannusspissamentum4423]

Before i ordered these I did a "add a fuse" to my running lights fuse in the front passenger floor fuse panel...beats cutting into harnesses. Especially if the cut leads to corrosion down the line.

[@tyrannusspissamentum4423]

Also I had added two custom LED strips to each of the front facing reflectors on my mirrors. One strip was for flashing. The other was a running light. Its the reason I used a "add a fuse" in the first place.

[@BiggsWrld]

That’s a good idea for sure!

[@tyrannusspissamentum4423]

@@BiggsWrld It'll make installing these sequentials a breeze. Thank you for your uploads on these switchbacks. Also as a side note or note for the future. If your DRL switchbacks in your headlamps ever start hyper-flashing or flashing white intermittently while the signal is still on and it isn't a bad resistor. Also the signal on your dash won't flash any differently, like with most hyper-flashing issues when resistors aren't used. Try changing out your ignition switch. (I've had my switchbacks in my headlamps since 2014 and about 3 years in they would do as I described above. I tried changing both of my resistors, I cleaned up multiple ground connections and I couldn't figure it out until my starter took a shit at work. After I tried changing the ignition switch and starter. I realized they no longer acted goofy. I could be assuming a little here, but I highly doubt the starter was the cause of the issues. Another hint you have a bad ignition switch is your key when turning will have zero resistance to rotation you may also see your dash light flicker as you turn the key to the start position.)

[@tyrannusspissamentum4423]

@@BiggsWrld Correction: I thought I heard you say you had DRL's in your headlamps as well. Ignore that part of my comment unless you install them later.

[@jamesnapper716]

I have the same lights. Could you explain and show where to wire the wire to the pin six?

[@BiggsWrld]

I have two KZbin shorts on my channel that might help! Let me know if you have anymore questions.

[@americanmuscleguy7544]

My Truck didn’t Come with Signal Flashers on my Mirrors Can I Still get them to Work?

[@BiggsWrld]

Yes, you will have to do a little more wiring tho.

[@jonatanhernandez-e2m]

Did you wire all 4 mirror lights to the same pin ? Pin 6

[@BiggsWrld]

Correct

[@wyattcormier4236]

Are the rear-facing lights blinding at night?

[@BiggsWrld]

If you don’t have tint I’ll be honest yes kinda. Definitely manageable.

[@ryanschultz746]

did you buy those mirror caps somewhere or paint them yourself?

[@BiggsWrld]

Came on the truck.

[@beauxjones1942]

Where is pin 6. Like the location on the truck. I’m tryna get as much information as I can before starting this project

[@BiggsWrld]

Passenger kick panel

[@justinheard5954]

45 where can I find 12-volt setting my mirror I just never had to order the lights on and turn it on the back side so I'm trying to find power to where I can renew my other one in front of the marking light

[@BiggsWrld]

If I’m understanding correctly you will plug the front facing switchback into the back facing switchback and that how they work in unison.

[@landonethington5500]

I bought aftermarket mirrors with the turn signals in them but the factory white plug, that plugs into the bigger prongs on the rear facing light isnt there on mine. Any suggestions?

[@BiggsWrld]

I’m not sure, are they normal after style aftermarket or aftermarket tow mirrors?

[@landonethington5500]

@@BiggsWrld they are regular mirrors with the signals like your factory ones. Just made for a 2004 f150 instead. Everything is plug and play except for the plug that plugs into the rear facing turn signal . It doesn't have the white plug with the prongs facing vertical and horizontal.

[@BiggsWrld]

@@landonethington5500it might take you one more step you will have to wire the two together then.

[@landonethington5500]

@@BiggsWrld so I would just splice them together directly and solder then directly to the wire on the aftermarket plug

[@landonethington5500]

@BiggsWrld I got everything wire up and it looks fantastic. Thank you so much for the help

[@jacobolivarez8752]

Have they held up?

[@BiggsWrld]

So far so good!

[@gavo5629]

Holy smokes Biggs never know you had a KZbin channel. Keep it up 👍🏻

[@BiggsWrld]

I do! Thank you I hope you enjoy 🤝

[@Burdskie]

So if I only want mine to turn white when the headlights turn on, which wire do I tap into? I don’t want them on during the day?

[@BiggsWrld]

That’s how these are wired if you headlights are on these are on if your head are off the white isn’t on and you will just have the sequential turn. Hope this helps!

[@Burdskie]

@@BiggsWrld ok cool. Thanks bro! That’s what I thought but just wanted to check before I put them in

[@colinlewellin7957]

do you think you could possibly show where you tapped into the truck yes i know the 6th pun but do you think you could show how you tapped in?

[@BiggsWrld]

Absolutely DM me on IG Biggs.Wrld

[@davidconder8031]

@@BiggsWrld where did you tap onto on the driver side

[@Chodethequackmaster]

Got everything wired but it blows a fuse immediately. Any ideas what the issue could be?

[@BiggsWrld]

Trace your wires make sure you don’t have wires swapped also double check your pin and make sure it’s correct. Lmk if that worked.

[@tristanmorgan1851]

Which wire did u tap into on the headlights

[@BiggsWrld]

It should be the yellow with blue tracer wire. Or passenger kick panel look at pin #6 on the 10 pin harness. Hope this helps if not DM me on IG

[@lobbcityyy]

Bought these for my 2014 f150 and both of my mirrors only have 1 clip for the led reflectors

[@BiggsWrld]

Yeah you chain them together

[@Chodethequackmaster]

How did you get the wires through the door boot into the cab?

[@BiggsWrld]

Depending on what boot you have you can feed it through the boot but if you have the gray one I just pokes a tiny hole and ran it through the outside of the grommet

[@elrican09]

Great Video and nasty truck. What's your wheel set up?

[@BiggsWrld]

Thank you! 24x14 33x14.5

[@BiggsWrld]

Are These Truck Tires Worth It!? (Versatyre R/T HD) kzbin.info/www/bejne/eZTQc5yPYqaWoJI

[@elrican09]

Another question are they really bright? I know if the video yours are just wNted to check before buying. I have a white f150 just wNt to make sure they pop. Yours look amazing!

[@FusionAdapt]

How long did it take you do it?

[@BiggsWrld]

Several hours

[@98snakehorse]

Why not show where the 10pm/12pin connected is lol

[@BiggsWrld]

I have a whole other video and two shorts explaining it……. lol

[@buddyperman3226]

How did you get the power wire (2 red ones) through the mirror

[@BiggsWrld]

Fed if through with all the other wires in my mirror.

[@branden096]

@@BiggsWrld how did you get the red wire out of the door

[@BiggsWrld]

@@branden096 you have to take ur door card off and feed it through the boot or grommet.

[@trip446]

@@BiggsWrlddid the power wire come with it or did you buy speaker wire

[@peytonridley1774]

Where did tap in at for driver side

[@BiggsWrld]

You tap in to the same pin as passenger side, pin 6 on the 10 pin connector on the passenger kick panel. I hope this helps.

[@justinkidwell7526]

I cannot find that pin on Driver's Side for nothing

[@BiggsWrld]

It’s on the passenger side.

[@justinkidwell7526]

@@BiggsWrld gotcha man I appreciate it I seen your short video thanks man

[@justinheard5954]

54 yeah I think I was going time anyway to write find closest to 12 volt Samia switch drive to tied into my damn driving lights or something maybe

[@BiggsWrld]

Yeah you can splice them into you headlights parking lamps

[@6969raider]

The white LEDs come on automatically when you turn your car on and they stay on all the time

[@BiggsWrld]

No, They Come on when your headlights are on. As long as you have them wired to your parking light.

[@davidconder8031]

Which one did you tap into on the driver side?

[@BiggsWrld]

Please look at the rest of the comments and watch my KZbin shorts it should help.

[@Josevga03]

Where is the parking wire?

[@BiggsWrld]

Have two KZbin shorts on my channel that should help you out!

[@Josevga03]

Hey I checked them out they still didn’t help🤥you would mind ft😭

[@carterrobinson6087]

Why didn’t you just connect the white light to the puddle light which is a park light under the mirror

[@BiggsWrld]

Unfortunately the puddle lights only have power when you open the door or click your key fob I wanted them to be on while driving

[@jjosevvega1318]

Can you do a video at night while driving I wanna see the white leds

[@BiggsWrld]

I can but I’ll redirect you to my Instagram or TikTok so I don’t have to do a whole video Biggs.Wrld

[@jjosevvega1318]

@@BiggsWrld send it

[@AMOffRoad]

Hello, are you interested in working with us? We can offer you sponsorship

[@BiggsWrld]

I would love to! Email me [e-mail]

[@redsonfly305]

Please change the name of your video to a review and not an installation. You didn't show anyone how to install them. Thank you

[@BiggsWrld]

Thanks for your feedback I have other videos on the channel that can help with any missing information 👍