How to program a remote on a Chamberlain garage door opener

[@wanderinivy1200]

Best Video ever .. you really helped me .. I watched ten videos I could not get my remote to work ...this video fixed my problem very Helpful

[@Gdguy109]

You need to shorten the emergency release cord at the top of the door

[@javedubare1997]

Hello. I would appreciate if you could let me know how to program to close the door. Opening works perfectly fine. Thank you.

[@alecsgaragedoor]

It could be either the travel or force what type of opener is it?

[@cashcosgriff2960]

Thank ya master

[@homeguestunton]

Why did you age restrict your videos.

[@dclem40]

Mine just keeps blinking after doing this i have to manually close it and hold it down on the primary garage button someone please help

[@alecsgaragedoor]

It may be your safety sensors check and see if there aligned if not check the height it should be 6 inches off the ground. Also both of your safety sensors should have both lights on. And if not check your wiring if it was chewed or if it’s like starting not to go good. So if either of those problems do not work buy new sensors for those. Hope this helps you with your problem

[@gmtrumanandrade6145]

Same here. I recently bought that remote control same as yours, and it only opens my garage door but won't close and it just keep beeping but never close, the sensor green light on both side, i notice only one is on the other left side is not ON. Hope you could help me out

[@alecsgaragedoor]

@@gmtrumanandrade6145your sensors could be either misaligned where you could try to realign it or it could be the wire or it could be one side is one measurement often the other both sensors have to be at 6 inches and it can’t be no longer than that. I hope this really helps you out. Please let me know if you have any other questions.