"How to Rebuild a Honda Civic Power Steering Pump | Complete DIY Guide"

[@PrinceSteering-nh9mj]

Am a steering engineer by profession I work and repair all kinds of steering pump and racks for all kinds of cars

[@DayanEngineeringWorks]

Good luck

[@PrinceSteering-nh9mj]

@@DayanEngineeringWorks hello sir can I work in your company

[@eshanpalipana4444]

🔥

[@DayanEngineeringWorks]

❤❤

[@bosseta]

Thank you, helps a lot! How to know the correct slot of each fin?

[@DayanEngineeringWorks]

Its better you can mark it. However if all fins are same size, ( after checking through micrometer , vernier caliper) its doesent matter the slot number.

[@bosseta]

@@DayanEngineeringWorks Thank you friend!

[@scottbryant7090]

I’ll bite. What parts do I need for a 2008 Civic DX 1.8 liter.

[@DayanEngineeringWorks]

For rebuild the pump? It doesnt matter which model or year.. just disassemble it. You can see the seal and bearing numbers and buy them..

[@dominiccapa2735]

Boss tanung lang po anung size ng bearing para power stering ng 96 model honda civic bigote .thanks po

[@DayanEngineeringWorks]

Not sure about the exact size mate. But you can check it by only removing the pump pully. I think its 6203

[@tdxibr5366]

Bro the fins you placed, where was its rounded edge pointing and where was flat edge pointing

[@DayanEngineeringWorks]

Flat edges inside - round edges out side . Just imagine centrifugal force. If the flat edge faced out side , the outer ring may damage.