How To Remove A Garage Door Openers Wall Control

Simple video on how to change a garage door openers wall control.
Some people may not know how so I hope to cover a lot of information even if some videos seem super basic.
Wall control in video: amzn.to/2JJrg2i
Assorted wall controls: amzn.to/2ANyOy0
Parts page: www.garagedoor...
Thanks for watching and hope this helped ! Don't forget to subscribe (:
Tools you might need / Tools I Used:
Makita impact driver - amzn.to/2rtIE2H
Screwdriver bit set - amzn.to/2En9aTX
Reversable screwdriver - amzn.to/2L7AtSP

[@miguelcarino4610]

Muchas gracias por el vídeo lo andaba buscando hasta que lo encontré

[@tinacombs3115]

How do you replace the exterior keypad and how do you know which model to buy in 2023 if you have a much older model installed?

[@GarageDoorGuidance]

It would really depend on what you have there. If it’s older than 25 years chances are you’re better off buying a new opener with a keypad in the box

[@OscarGarcia-yb3lw]

Thanks.

[@jhabner1234]

Mine stopped working last night after a power outage. Thoughts?

[@GarageDoorGuidance]

Logic board likely, a lot of the times they’ll get burnt out with the surges. ( logic board on the motor, unless everything else still works )

[@jhabner1234]

The door works with remotes. There is a flashing yellow light on wall mount but it won’t operate the door. I tried to pair it using the button but it didn’t work.

[@GarageDoorGuidance]

And this is the same button as in the video correct ?

[@jhabner1234]

Well, Liftmaster, but looks the same otherwise

[@GarageDoorGuidance]

I would try to swap the wall control. Amazon has them and worst case you can just return it

[@Zack16Fair]

Is it possible to relocate mine, it's a bit higher than it needs to be. I unscrewed it and there's this metal frame that it's screwed to. It's not a box, it's a square metal frame

[@GarageDoorGuidance]

I’ve never seen a metal frame for one before, it should just be wires back there than you can easily splice and add length to.

[@charleslyons6764]

I need some assistance, what would be a good way to message you?

[@GarageDoorGuidance]

Gargedoorguidance@yahoo

[@bangchayrattanaphon2178]

Thank you

[@vickirushing8298]

I have an old Wayne dalton garage door opener. My remote works the device, but the wall mounted piece probably needs a new battery. How do I get into it to change the battery?

[@GarageDoorGuidance]

If it’s a Quantum, you need to use a flat head screwdriver to pop the cover off

[@vickirushing8298]

@@GarageDoorGuidance Thanks, it worked.

[@Boba_DoorMan]

Thank you!!

[@janetayala1717]

Does this device on the wall require batteries? Or is it plugged from behind?

[@GarageDoorGuidance]

Usually hard wired to your opener

[@theka4972]

For some reason mine isn’t flashing the yellow light, the garage opens and closes but only with the panel outside

[@GarageDoorGuidance]

Panel inside the garage that is wired not working?

[@maryowen6358]

Thanks

[@DAVIDGLOPEZ]

Thank u so much

[@heechulsong21]

Thanks!

[@georgepascal1163]

I wish you just got to the point! I just wanted to see that hidden screw

[@GarageDoorGuidance]

Sorry. What can I say it was hidden..