Great video, after watching it, it took about three minutes to tighten the hex and install the lock. Thanks!
@76vette2 ай бұрын
Glad to hear it was helpful. Thank you for watching! 😊👍🏻
@manoffaith25012 ай бұрын
Excellent explanation of method to remove/install glove door lock. Thank you very much, it was extremely helpful.
@76vette2 ай бұрын
Thank you for watching! 😊👍🏻
@KevinJames-yg9eu2 ай бұрын
The first pin is the only one that you have to push in with a pick or screwdriver. The next four are tumblers that are pushed in by the key. Hold the latch closed to take the spring tension off the lock cylinder. Push the first pin in and pull the knob out until the cylinder stops at the second pin. Insert the key. You may have to wiggle it a bit. Pull the knob to remove the cylinder. It should basically fall out under its own weight if you have it pointed down. To reassemble it, insert the key into the cylinder, hold the latch closed, push the cylinder in, and remove the key..
@76vette2 ай бұрын
That makes a ton of sense, so I’ll give it a try if I ever need to. Thanks for taking the time to share this tip! 😊👍🏻
@Cube12048 ай бұрын
Funny, I recently did a guide for this on the corvette forum. Great work and very accurate
@76vette8 ай бұрын
Thank you for watching! 😊👍🏻
@musclecarmitch9088 ай бұрын
Great demonstration and tutorial on the glove box lock removal! Thanks for sharing!👍
@76vette8 ай бұрын
Thank you for watching! 😊👍🏻
@jimmarkevitch8727 ай бұрын
🤠Fantastic . . . . . Glad I'm not the only one who sat like a "village idiot" trying to get the lock out of the glove box. Thanks!
@76vette7 ай бұрын
Thank you for watching! 😊👍🏻
@donhenderson51008 ай бұрын
Once you clean the lock, do you apply a light oil to it? Just to keep springs and clips intact. I love these videos. This is how everyone can improve their cars on your own, many times for minimal cost. Corvettes are crucified foe rattles on the interior. Little things like this keep that in check.
@76vette8 ай бұрын
Yes, a squirt of WD-40 or graphite lube never hurts 😊👍🏻
@Truck-Train-Ship-Car-Bikelover6 ай бұрын
I use a chisel the are octagon ( 8way ) and it fit in the nob ....work goods for screwing that nob. thank for placing this video, works good and simpel to remove and instal the key cilinder, thanks mate.
@76vette6 ай бұрын
Thank you for watching! 😊👍🏻
@Truck-Train-Ship-Car-Bikelover6 ай бұрын
Same lock as in my 1973 caprice, it was stock, i clean it out all the pens and refit it , works now good @@76vette