How to Remove and Replace a Vespa GTS ECU Throttle Body

Service for programming new lock set to existing ECU:
www.scooterwest.com/extract-k...
How To Change the Column Lock on a Modern Vespa: • How To Change the Colu...
How to Program a Vespa Key: • How to Program a Vespa...
For the largest selection of parts and accessories in North America, please visit our website:
WWW.SCOOTERWEST.COM
Thanks for watching!

[@luckystrike3786]

I don't have a Vespa but I like to do some basic maintenance on my car/scooter and it's always a pleasure to see how a professional mechanic works. Italy

[@marcustalman2756]

Great vid 👍 from a wet and windy UK.

[@cagatayguven7025]

Thanks Robot! Learned a lot.

[@Driver-zw9sy]

good video from the netherlands europe..

[@roywalls5595]

Thanks for video Mr. Robot! On my 2007 Piaggio mp3 250ie real dirty I need wash every thing down! Tell one thing my never been changed out back 2006!

[@richarddavis1884]

Good information. Thanks Robot!

[@VespaMotorsport]

Glad it was helpful!

[@emiliotrujilloelizundia1128]

Great exolanation! When do we need to replace the ECU?I mean, if there is a hesitation in aceleration?or any other sympton?

[@user-ze9ot9rw3l]

Hi, Thank you for your share the process. After replacing the Throttle Body that needs to do reseat of TPS.....Is it?

[@Designer_Opine]

Tasty. This clip is Designer approved ✅ ❤️🛵🤖

[@ec_one9707]

Hello, thanks to your videos. Sorry my english ist not so good, because i came from swiss. Do you have a video about change the start button (switch) an a Vespa GTS 125 Super Sport iget from year 2020. or do i have to remove the steering wheel cover to change the startbutton? thanks you for help

[@gavincurran2244]

Needing to replace the spring on the throttle return as think it broke. Is this easy to remove?

[@josedelgado5959]

Good night I have a Vespa 2009 gts 250cc engine. I turn it on and it chokes and it turns off. Can you help me?

[@bumpintheG]

What about a 2010 50lx? Please respond

[@orfeas92]

Please, make a video of how to clean this Throttle body!

[@persiko570]

I have installed a virgin ECU with a new key lock kit. Now the Vespa does not start and the Motor Engine Light does not disappear. Any tipps for me?

[@roywalls5595]

On my ECU talk about the key I only have red key for it because dealer lost it black push bottom when rental it out!

[@mockfly4702]

🤙

[@tamapra57]

Hi, today I go to PADS my vespa and the results are: P1003 - Dirty throttle body - signal too high - ATT P0031 - Oxygen sensor heater Voltage low - S.C. to Gnd, O.C. - ATT P0261 - Low Voltage injector - S.C. to Gnd, O.C. - ATT local mechanic said I have to re,place the Throttle body and the Oxygen sensor. Is it true? Since it's quite expensive

[@dhruan]

Hi shop, I have a Vespa GTS250ie 2011, now it's ECU has problem, it has high garanti. Now Can I adjust the garanti for lower? or I should change a new ECU throttle body. please adive me. Thanks

[@ashrafas2189]

Hi am looking for vespa throttle lxv 150ie 3v 2016

[@liberopastorelli5465]

Ciao. Ho un problema che mi affligge da tempo . Il mio Beverly 300 tende ad avere un minimo irregolare, a singhiozzare in marcia ed ad imballarsi fino a spegnersi. Riaccendo e riparte subito per poi ripresentare le stesse anomalie. Da come si manifesta il tutto, sembrerebbe il corpo farfallato sporco. Ho provato a pulirlo con uno spray dal condotto filtro ma invano. Mi consigli di smontarlo e pulirlo accuratamente? Ti ringrazio e scusami per il disturbo. Hello. I have a problem that has been affecting me for some time. My Beverly 300 tends to have an uneven idle, sobbing in gear and packing up until it dies. I turn it back on and it starts again immediately and then re-presents the same anomalies. From how it all manifests itself, it would appear that the throttle body is dirty. I tried to clean it with a spray from the filter duct but in vain. Do you advise me to take it apart and clean it thoroughly? Thank you and sorry for the inconvenience.

[@ricbar437]

Hello mr Robot , I’m following your videos for a while now , and today a problem occurred on my Vespa 300 gts hpe 2020 notte (6000km) that I can't solve ; My vespa was working perfectly well, after a stop I wanted to restart ... impossible, the starter works the engine too but does not engage, it is not powered, no spark at the spark plug even after changing it After a check to the odb tag nothing to report. Something is blocking the ignition I have only the blue key and not the red/violet one Is it a problem of anti-theft key or electronic blocking? Have you already encountered this problem? Do you have an idea ? I from France and you are the only person with videos explaining the breakdowns and mechanics vespa ! Thank’s you 🙏🙏

[@elmerallasas5173]

its like no gas coming in?

[@Olivier-nb5iu]

Hi there, have you been able to fix the problem And of so what was the solution I have the same issue here, really frustrating 😢.

[@rolandschroeppel8570]

👍

[@rolandschroeppel8570]

Very good worker

[@juliodiaz4493]

I have a vespa gts supersport 300 2023 I need her fob where can I send the throttle body too you people

[@rti512]

TPS on may vespa GTS 2018 broke 5600 km 8 months ago factory refused replace the ECU with the excuse l have racing exhaust lolololol but l sed l will bay New l prepay 680 euro 💶 8 months pass no ECU arrive yet what l garbage skouter end what a garbage service