How To Remove the Rear Bumper Cover | Lexus GX470

[@roccol5360]

Thank you for the video, I had to pull off my bumper, same truck as you, just to replace the reflector. This was a tremendous help. 👍🏻🙏💪🏼

[@thatDIYlife]

Thanks. Helped me install a hitch receiver.

[@torreyinnewyorkcity334]

Thank you! I need the have my bumper part of the frame cut out and replaced and wielded. It’s all rusted. It’s a mess.

[@saintmalachy1924]

Awesome vid. Thanks for putting this out here👍

[@Semiam1]

Didn’t know about the vent. Thanks

[@diydaddy5092]

Thanks for the great video. I noticed you had to pull pretty hard to release the bumper cover. How is it on re install? Hard to snap the 2 sides back in?

[@crutchfieldautomotive7936]

Not terrible, I should have pulled to the side more, there’s one clip that holds them that’s tough

[@johnwarren5864]

What does that little black hose on the back left run to? Is that an air suspension line?

[@crutchfieldautomotive7936]

It does come off of the air compressor but I’m not 100% on what it goes to once it enters the body again

[@paulhunt1580]

I've been on the lookout for a white bumper on for my wife's 08 GX...is that one up for sale?

[@crutchfieldautomotive7936]

It is. Email me [e-mail]

[@torreyinnewyorkcity334]

👍🏼👍🏼👍🏼👍🏼. I need to know how to do this!

[@g2racing]

Do you want to sell the old cover?

[@crutchfieldautomotive7936]

Had to use parts of it with the steel bumper I have a front one but not a full rear one