How to remove your gas tank and clean it! My 1986 300zx z31

  Рет қаралды 12,506

The Z Garage

The Z Garage

Күн бұрын

Пікірлер: 35
@zane7433
@zane7433 2 жыл бұрын
Watching all the ads every hour again😂😂best video for my 85 turbo now replacing fuel tank love ya bro hella years late
@AlfredJones-mr1yh
@AlfredJones-mr1yh 6 ай бұрын
Changed the CAS as per video.But had to force rotor off was seize there for some reason didn't look like any loctite or anything there now. Car runs worse than ever. I don't know if I knocked it out of time or not or is it a bad cas?
@datzkar
@datzkar Жыл бұрын
Did you ever figure out a good way to coat the inside? Looking at dropping mine because the fuel coming out is a little.. orange.
@ofirtal6497
@ofirtal6497 4 жыл бұрын
Very nice review! I liked the fact that you did some mistakes but you kept trying!
@eduardobecerra5570
@eduardobecerra5570 6 жыл бұрын
Hello Josh, my name's Eddie, and I recently purchased a 1987 Nissan 300ZX. I'm having an issue in regards to my fuel gauge showing the car as less than half full, even when I pump gas and filling her up. It's telling me I am running on less than half the full tank, but when I go to fill up the car, it only allows me 2-3 gallons before it fills up. If I force it anymore, it overfills. Would you recommend replacing the fuel sensor in the rear? Or would it require me to clean in out like you showed us here? Just want to say I really enjoyed the video - you did a great job and were very thorough. I'm going to watch all your other videos now as this is going to be my project moving forward. Hope to hear back from you - thank you!
@eduardobecerra5570
@eduardobecerra5570 6 жыл бұрын
Joshua Crepeau thank you for your reply! I failed to mention my Z has a Digital Dash. I was looking up the OEM parts and it said it wouldn't work on the digital fuel gauge. So the part you ordered from Amazon is different in that it used a floating device? Would I just disconnect the blue connector device if it's still in mine? Sorry a lot of questions.
@drqusk
@drqusk 4 жыл бұрын
I just started my z31 build.. Noticed your in ABQ. Would love to chat about the car and things to expect.
@raulsoliz673
@raulsoliz673 3 жыл бұрын
special tool to take out the tank strap nut that has long threaded bolt? (drives side) regular socket nor box end wrench could reach it
@TheZGarage
@TheZGarage 3 жыл бұрын
A deep socket or ratcheting wrench work best
@Nissan570sx
@Nissan570sx Жыл бұрын
So apparently if you leave the acid in too long it will dissolve the plastic baffle around the fuel pump... ask me how i know
@FullBloodZombeh
@FullBloodZombeh 5 жыл бұрын
Any tips on how to get it back in? I'm having a really hard time lining it up and putting it back in than I did getting it out and it probably doesn't help there's almost half a tank of fuel in it. It's really hard to keep it balanced on my floor jack with the fuel sloshing around and it feels oddly lopsided. On top of all that I have to jam the fuel lines back onto the nozzles with little to no hand room. I have half a mind to just cut a spot in the trunk to work with it lol.
@TheZGarage
@TheZGarage 5 жыл бұрын
Yeah I've had the exact same problem trying to get mine in lol. The best thing that you can do is if someone can help you position the tank and then rest it on jack stands or blocks of some sort while you connect the lines then lift it up into the final position. A lot of people do cut a hole in the trunk though haha
@marquezjoel9682
@marquezjoel9682 4 жыл бұрын
Dump the fuel in containers and put it in
@KnineLiveZ
@KnineLiveZ 7 жыл бұрын
Damn what kind of camera are you using? quality is really good lol.
@angelc8271
@angelc8271 4 жыл бұрын
How did you remove the sender unit? I removed the screws but the plastic cylinder doesn't come out
@TheZGarage
@TheZGarage 4 жыл бұрын
It is most likely seized on the tank. As long as all the bolts are out, nothing will be holding it in. Try getting a small flat blade and prying the edge up
@angelc8271
@angelc8271 4 жыл бұрын
@@TheZGarage Just got it out a little while ago, I ended up pry at the metal blade in the center of the unit, don't know if it did damage but I'll probably just end up replacing it, if there's still replacements out. 🤔
@angelc8271
@angelc8271 4 жыл бұрын
@@TheZGarage As for the acid, I might just use vinegar, hopefully it works well.
@JB-xu6uq
@JB-xu6uq 3 жыл бұрын
How did you remove the straps
@TheZGarage
@TheZGarage 3 жыл бұрын
Support the tank with a jack or something, then there are 12 or 14mm nuts on the straps on the side next to the differential. Undo those and the straps will come down. Then twist them sideways to get them out of the rear hinge
@benjaminnielsen4288
@benjaminnielsen4288 6 жыл бұрын
Hey man, this is a good video. keep 'em coming. by the way, this is Bon from Zcar.com
@benjaminnielsen4288
@benjaminnielsen4288 6 жыл бұрын
ehh, its going but could be better. i just picked up an AE turbo with 46000 miles and within two days, someone in a lancer backed into me and the first major overheat occurred (it being a Z31, I expected this) so now I'm waiting for an upper rad hose to get here from the states. So now its just sitting waiting :( love these cars but i hate thier damn cooling systems. btw your 87 is a lot like my 87, except i minds gold outside and is the digital model. you got a whole bunch of videos on here, i never seen them before. btw, where are you from can i ask? the scenery looks like my own Utah, or maybe NM or AZ. just wondering. cheers.
@benjaminnielsen4288
@benjaminnielsen4288 6 жыл бұрын
i mean 86. haha sorry
@benjaminnielsen4288
@benjaminnielsen4288 6 жыл бұрын
thats what i thought lol. the AE is rare for sure. maybe you'll have one someday! never know... my 87 has the maxima cooling fans and they work quite well actually. make sure you get a better alternator to handle the load. looking forward to more videos and i'll see you over at zcar. take care man -Bon
@Rabbitocity
@Rabbitocity 4 жыл бұрын
Hey dude how did you remove your sending unit?
@TheZGarage
@TheZGarage 4 жыл бұрын
The hole in the rear hatch is the sending unit. Just take it off and undo the bolts on top of the tank. Then pull the unit up and out. Very simple. If it's stuck, use a flat blade to pry it up.
@shaunirwin3640
@shaunirwin3640 3 жыл бұрын
Good videos Thanks for posting. Keep it up.
@sniper1958
@sniper1958 5 жыл бұрын
Great job kid
@TheZGarage
@TheZGarage 5 жыл бұрын
Thanks but I'm actually 20 at this point so not quite a kid anymore haha
@sniper1958
@sniper1958 5 жыл бұрын
Meant no disrespect. I have a 86 ZX that I've had for 33 years still looks great.
@TheZGarage
@TheZGarage 5 жыл бұрын
Haha no worries! I was just messing with you. That's great! I'm hoping to be able to repaint mine before the end of summer so it looks shiny and new again
@MegaCyberleader
@MegaCyberleader 6 жыл бұрын
my hero
@grshprtoy
@grshprtoy 9 ай бұрын
You need to invest in a reall jack!!
How to drain your coolant! My 300ZX Z31
5:26
The Z Garage
Рет қаралды 9 М.
How to Remove Your Dashboard! (300zx Z31)
26:10
The Z Garage
Рет қаралды 14 М.
REAL or FAKE? #beatbox #tiktok
01:03
BeatboxJCOP
Рет қаралды 17 МЛН
Beat Ronaldo, Win $1,000,000
22:45
MrBeast
Рет қаралды 158 МЛН
How To Remove Rust From A Motorcycle Gas Tank
16:35
Tom's Tinkering and Adventures
Рет қаралды 127 М.
Deleting HICAS on My 300ZX - Is It Worth It?
21:08
Billy Built
Рет қаралды 1,7 М.
GAS TANK--CHEAP--RUST REMOVER !!!!!!
15:19
Cycle Fab
Рет қаралды 906 М.
Siphoning gas out of a bmw
8:24
Morgan Haney
Рет қаралды 31 М.
DON'T EVER CUT THROUGH THE BED! HERE'S WHY! - Fuel Pump
14:50
Roadside Rescue
Рет қаралды 97 М.
Is a Cat Delete Worth It?
16:34
Donut
Рет қаралды 6 МЛН
REAL or FAKE? #beatbox #tiktok
01:03
BeatboxJCOP
Рет қаралды 17 МЛН