How to replace a front engine mount on a 2003-2007 Honda Accord V6 3.0 PART 2!

DISCLAIMER I'M NOT A PROFESSIONAL DO THIS AT YOUR OWN RISK!
When accelerating, I could hear a clunk or pop sound when the engine was under load. Upon further investigation with a flash light, it became clear what that noise was. I could also feel vibration in the steering and seat. I hope this helps. Thanks for watching. Be sure to hit that like 👍 and subscribe for more awesome videos!
Tools needed :
Breaker bar
Crow bar
14mm wrench
10mm socket
17mm socket
Many extensions
Floor jack
Jack stands
2x4 wood
Enjoy! Thanks for watching! Hope you found this helpful!

[@user-yw1du6dt8b]

I did this a few years ago, have to do it again and needed a refresher. This was a great video thank you. Wish I had it then lol but others got me through enough

[@4WheelingBrian]

Thank you for the kind words! I really needed to get this done on the car it was clunking so bad under acceleration. Not too bad of a job but I do know that a mechanic would have been a ton more money. Thanks for watching!

[@danzemskov]

One very important thing. How you pulled out/inserted engine mount? Because there is very little room for this.

[@4WheelingBrian]

It's a very very tight fit, I had to unplug the o2 sensor and remove that bracket for the connector and still was a tight squeeze. But with some patience and turning the mount the right ways it came out.

[@danzemskov]

@@4WheelingBrian your manual is great. I replaced front and right mount. But I have some problem with rear mount now. Maybe do you have manual how replace it?

[@4WheelingBrian]

@danzemskov I will look into it for sure. Thank you for watching!

[@aaronm.1998]

Thanks for skipping how you removed the 4 bolts.