How to replace a softball bat end cap

[@cargilb]

Nice music, "Let the music play." I love 80's music

[@alyshafresquez5245]

I’m wondering where you bought your end cap? Also what does the bat look like and how well does it work after the seven days?

[@rickygunawan435]

How did you remove the cap from the bat ?

[@rickygunawan435]

How did you remove the cap from the bat without breaking the cap ?

[@jrey6186]

Looks like he used a bandsaw - caps as shown on replacement have a sleeve [which appears to be still inside the barrel]

[@howardjohnson5734]

hysol u05fl may be a good choice ,because it is 2 part if you put it in a closed pill bottle it still will set up .being a urethane it can be hit and not crack .

[@csebastian71]

Do you rotate your strap 90° throughout the curing time or do leave it in one position for the 7 days?

[@joegrasso5371]

Hi Sebastian, No, you do not have to rotate the strap. The strap is just to hold the cap down while the glue cures. Rest the bat with the cap down while the glue cures. So that if you over glue any excess glue will seal in around the inside edge of the cap and the bat. Do not to over tighten the strap, the cap material is really soft and pliable and the strap will leave an impression on the end of the cab if you over tighten it! good luck.

[@everynavanava6530]

I will arrange a friend catality bat boto brings the top but inside as a Silicom and ammunition will place another cover and stay well my question is left with the same performance on contact with the bal

[@marcoangel890]

hi people, i have a Catalyst TPS 2 1/4 in Barrel (yellow bat)and i need the end cap.. I do not know where to buy it........ CAN SOMEONE HELP ME?

[@luisgaeta8343]

marco angel check batwerxs.com I just ordered 1for an Easton

[@marcoangel890]

luis gaeta thanks you so much... 💪🏼

[@luisgaeta8343]

marco angel let me know if it was a good lead

[@howardjohnson5734]

hysol sets up in 5 minuets and reaches full strength in 24 hrs

[@Babymc1515]

how did you take the cap off

[@joegrasso5371]

+Babymc1515 How to remove the end cap. Use a drill with a 1/2" bit drill and drill through the center of the cap. Then use a pair of pliers to pry and break away the cap. If the edge of the cap does not remove from the bat wall, you can then use a flat head screwdriver and hammer between the wall of the bat and the cap and slowly breakthrough the edge of the cap and bat with the screwdriver to remove. Note be careful not to get too close to the edge of the bat and mistakenly drive the screwdriver into the back wall!

[@jrey6186]

Send it to a pro service - no offense but garage hacks are just that and your prized stick will suffer!

[@kendallwolfe1507]

People using shaved or rolled bats is like athletes using roids..

[@jrey6186]

This is not promoting shaved or rolling - tryna fix a shit cap - pay $50 and have a pro care for your stick, smfh