How to replace Accelerator Pedal Position Sensor Yukon Denali and other GM vehicles 07-2013

How to replace your Accelerator pedal position sensor this goes for all 07-2013 Tahoe, Sierra, Silverado, Yukon Denali, Yukon, Suburban in less than 15min first disconnect your battery then with a flat screw driver remove wire clipp after that start removing your 10mm bolts then remove part ( tools needed 10mm socket and ratchet + extension flat screwdriver ) reverse process when putting in new part like/comment/subscribe/share my videos

[@23JustinBlake]

This was a great straightforward video and very easy to see and understand thank you very much. Most videos you can hardly tell what the heck is going on and a lot of times you can't even understand the person, thank you very much for making a great information video, I will now be heading outside to do this on my Chevy tahoe.

[@TenacityQ]

Thanks for taking the time to post this. I wasn't finding the top nut.

[@GosselinFarmsEdGosselin]

Thanks for the video!! Had it figured out, just haven't figured out how to get the safety latch on the plug unhooked... Don't want to break it!! As for unhooking the battery, won't hurt anything, but most likely not necessary. As long as the ignition is off, there shouldn't be any power to the potentiometer. (AKA throttle control switch)

[@eddielopez679]

Ur the man dude u helped me fix my problem

[@1carmea]

Thanks for the video! The dealership is ripping people off for such a simple fix. I live in Minnesota, so I will be replacing mine as soon as it warms up a little. :0)

[@marco1devo720]

Thanks for the awesome vid!!

[@farmanshaikh6405]

Great video 👍 thanks for sharing!

[@efrainavena2672]

thank you that was very helpfull

[@handyrams4664]

Mine was $110 bucks. Throttle cable set up would never have this problem. Kinda scary. I miss the old days.

[@fernandoarroyo8884]

Gracias vato 💯

[@123MRPARROTHEAD]

Thanks for the video I just wished it was a 2009 Chevrolet impala because I have one ordered now

[@terrenceking3536]

thanks for the info, very helpful and straight to the point.

[@Desmadre_tv]

Terrence King Thanks for watching hope it helped you out 👍✌

[@mike-ef7yq]

Hi, Do electrical gas pedals have to be re calibrated after 10+ years? My pedal isn't very responsive, its laggy, but when I push it down hard it goes, In my opinion the throttle cable is much better,, My car has been tested at

[@eyeonart6865]

All you need to change is the sensor not the whole assembly! those little silver screws on the side are holding the sensor on.

[@hmoodl755]

thanks for the vedio. great do we need to remove the battery connection ??

[@EseToker562]

Did you get p2165 code? I got this problem but don't know if is the tps or the pps cuz both have the same code

[@jasonrowlin8833]

Will the wrench light clear if you are disconnecting the battery and the reinstall the new pedal sensor will the light still come back on after everything is done or will it clear permanently?

[@williamraysv]

Do I need to reprogram the pedal to the computer?

[@howeyfeltersnatch7702]

This may be a dumb question, but does anyone know what the plastic Phillip's head lookin screw, on the bottom of the gas pedal on a 05 tahoe is for? Thanks in advance yall

[@durgeshyadavmachanical3381]

Super

[@scratchgolfermd]

This has come on 3 times on my 2019 chevy Tahoe RST and $1000 each time it happens. When is a recall going to take place?

[@versatile3169]

Thank you

[@Desmadre_tv]

No problem hope it helped

[@thomasdilbert4801]

If you unfortunately have the adjustable pedal model (my 2003 Tahoe has it) getting this assembly out to replace it, or to just replace the sensor, is a whole different challenge. But I eventually got it so it is possible to DIY.

[@bigdog1ful]

What you have to do

[@billykeeble5561]

My pedal is real sensitive. If I don't feather it I will be doing 70MPh before I know it. Will replacing this help?

[@clearedhot6146]

Did you have to recalibrate anything afterwards?

[@gonzofishing85]

Where did you order the part from?

[@alternateimpact81]

So what were the symptoms of your old pedal malfunctioning?

[@noelnybergborin3918]

My Nissan navara is revving by it self while standing in park, this happen after I changed the gas pedal/sensor. Why is this happening?

[@berthachavez6037]

Good

[@samantharothwell4168]

Can someone tell me is this is the same concept on a 09 hummer h3? I'm a 50 year old female and want to do the work myself. I want to do projects that I can do by myself, but I can't find a video for my vehicle. Thanks

[@versatile3169]

Does that sensor need to be programmed?

[@xtremetransportationllc6117]

What code was it throwing

[@versatile3169]

Where you bought your part at??? Auto zone doesn't have it

[@torryrussell]

Can u tell me what way the wires go

[@jewelld9275]

2013 Chevy Traverse TPS accelerator pedal replacement: How do you get the bottom bolt out? (1 of 3 sideways bolts!) Of course there is no way to get to it. Thank you.

[@jackcrilly2861]

You need a swivel to reach it, it's by feel only.

[@lifeaftersurgery-HugoCastillo]

Do you know if you need to relearn it ?

[@lisabolduc802]

#1stDISCONNECT BATTERYas is electrical👍🏻🤙🏻

[@danncurran5641]

no good at all management light going of when it wants pedal sensor I think any ideas ford focus 1.8 07 petrol

[@ricardoayala5028]

Why did you replace it what was the problem

[@edikoli4117]

Engine power reduce and . Increased engine idling speed. Vehicle does not respond if the accelerator pedal is pressed. Vehicle switches to "limp-home mode" Engine warning light in the cockpit illuminates. That’s why

[@JesusGuerrero-fe3du]

Throttle pedal sensor so if this goes bad would your vehicle only drive 15 miles per hour is this the fix?

[@bimmerboyy]

Mine doesn’t drive at all when it comes up just depends on

[@Joranalsa85]

excellent video, what were the reasons to replace the pedal? Could you help me with any signs or symptoms that may occur to take to replace the entire accelerator pedal?

[@stonigee7997]

Some sensors are connected to the pedal. So you wouldn't be able to only replace the sensor...You'd have to replace the whole pedal.

[@Joranalsa85]

@@stonigee7997 ok thanks you are friendly

[@chrisanzley6882]

was it giving off a code?? how dis u know to replace it??

[@Fearsomex23]

Chris Anzley if you are having throttle issues there is a voltage A and B. I replaced my throttle body and the issues continued a month later. So if one is bad the other will not work

[@bimmerboyy]

Okay so if I have P0641 which is circuit A then which is throttle sensor is bad

[@lightninghardhead]

was your reduce engine power on. mines is on

[@victor2187puj]

Did you fix your problem what was it i bave that too

[@Jesus-hl2wj]

victor2187puj did you ever fix your problem i am having that light right now after a couple mins driving and it showed a p1518 code so am guess its this

[@pacojerrte0]

what if I didn't disconnect the battery during the process?

[@Intrepid151]

You can get shocked or short circuit something.

[@keierawomack1152]

Not all gmc Arcadia is different

[@williamcruz364]

I have a 2009 escalade & It Does not Excelerate

[@Desmadre_tv]

William C If your check engine light is on take it in to your nearest parts store to get codes first to see what comes up and go from there 👌🏼

[@alejandrocisneros4345]

Fue mi imaginación o este wuey se echo un pedazo jajaja jajaja

[@paydrostylin7167]

You should probably show how to disconnect the battery and were it is to since that is a very important step. Especially since if you don't you could mess up a lot of stuff on the car if you don't.

[@maqjode]

Hi, I have a question. Can I just replace the sensor or should I replace the entire pedal?

[@b_rad5678]

It comes as one assembly

[@angelfelipe8155]

A pito metiorico

[@BeaJay477]

And the mechanic wants to charge $400 for this Bs

[@jfalters]

Is that an actual price you were quoted, or are you making that number up?

[@TTDFB1776]

Lol I bought this part yesterday for $70... stop the lieing

[@nelsonfernandez345]

So easy , I did it ......hahahahaha

[@victor2187puj]

What are the symptos for this cz im having reduce engine power

[@robraw101]

He’s not kidding, GMC service wanted $350 from to fix the throttle position sensor. I asked my friend who’s a mechanic and he said just change the accelerator pedal for $40 and you’re good to go

[@moejr14]

Will this fox the “reduced engine power”

[@Bert.1878]

Did you happen to get it fix? By changing this sensor

[@moejr14]

@@Bert.1878 No, I didn’t change it yet.

[@Bert.1878]

@@moejr14 so you still haven’t fixed it at all?

[@moejr14]

@@Bert.1878 I’ve changed the throttle body with a stock used on from the junkyard and it has been fine so far. I also changed all the grounds

[@Bert.1878]

@@moejr14 did it give you any codes

[@bghancock84]

Is not good to go. You have to adapt the pedal to the computer

[@williamraysv]

How can I do that.?

[@Simpleman57]

What kinda vehicle is this

[@hmoodl755]

thanks for the vedio. great do we need to remove the battery connection ??

[@deanmusson5206]

I've got a astra sxi z16xep and can't get out of limp mode it's really doing my nut in now any ideas or common faults