Just got mine in the mail today. kzbin.infoUgkxhcEDB3r-OJ3_X5hQzr7k1ZofTQy1ao_U The corners of the box was a little smashed but I think that’s more of the shipping’s fault. iPad was in perfect condition though. I ordered the yellow one thinking it was going to be a bright vibrant color. Instead I looks like more of a Gold color. I personally prefer the gold look. Definitely not disappointed but just a heads up to the ones expecting a brighter cream of yellow.
@deejsteriser4 жыл бұрын
Superglue is a terrible choice. Firstly, it dries hard and brittle; the proper adhesive (such as 3M VHB) offers a tiny amount of cushioning for the glass. Secondly, it's a pain to remove cleanly if access is required again. Thirdly, the vapour crystallises on contact with fingerprints or grease. Unless the glass is perfectly cleaned with isopropyl alcohol, the vapour can cause a clouding on the inside of the screen.
@TheFixTech4 жыл бұрын
All true, I was only showing how to do this repair with common tools. Best to purchase a new digitizer that has pre applied adhesive or a liquid type like 3m or b7000
@rodgerdodger34832 жыл бұрын
B7000 glue
@Michael-wy2iz3 жыл бұрын
I like the way you kept your head from blocking view. Good Job
@apexmike8495 жыл бұрын
Probably the best video so far. Shows me what to avoid, how to achieve the changeover and with enough close-ups to make sense of the tricky bits. I will use this one when mine arrives.
@aw69864 жыл бұрын
I honestly can’t see the cracks on his though the cracks on mine
@lucianovazquez36124 жыл бұрын
Underrated
@TheFixTech4 жыл бұрын
Thank you
@YouTooCanDo5 жыл бұрын
Hi. Where did you buy the digitizer? Amazon ? I bought mine on Amazon and it doesn't interact with my finger properly. Is the mounting pressure has impact on how the digitizer works ?
@stuartfell32143 жыл бұрын
Was that pry tools or razor blades
@draculagaming64304 жыл бұрын
I didn't get a black digitiser so I went with the white. Now my screen is white and home button black. Lol
@Disneyfamily893 жыл бұрын
Do I need clips to hold it together at the end?
@TheFixTech3 жыл бұрын
No clips, just use the double sided tape the screen comes with or the b7000 glue
@jayallan78855 жыл бұрын
you tape it with red double side tape, heat it back up and then put it face down on a flat surface with some weight on top. leave that there until it cools completely....i built a press out of plexiglass and nylon screws and nuts to seal up the ipads i repair. i leave the pressure on over night...
@alexfedorenko37854 жыл бұрын
Jay Allan do they sell the tape on Amazon?
@stevenrogersfineart42242 жыл бұрын
Good luck getting those cables back out with the sloppy super glue job :P
@TripleXDudey5 жыл бұрын
what i found funny i replaced my ipads home button (5th gen) its not the one linked to logic board and touch id still works wtf how did i do that?
@MD-xu8li4 жыл бұрын
Hello bro where do u buy this digitizer i need this
@rayhat51113 жыл бұрын
Great vid
@pabloherique76004 жыл бұрын
Hey man can replace the screen with iPad on? This dont let the Touch ID out?
@TheFixTech4 жыл бұрын
Best to turn off the iPad, Touch ID won’t de affected in any way unless you damage the Touch ID cable or button
@williamhugo72643 жыл бұрын
My screen is shattered and it likes to open random apps. Will I have to replace the LCD along with the screen or just the screen? The LCD works fine
@TheFixTech3 жыл бұрын
Just the screen screen, (digitizer)
@runforitman3 жыл бұрын
As long as the actual image looks normal, you only need to replace the digitiser as that is whats responsible for touch
@LeesReviews696 жыл бұрын
What kind of glue is “light glue” and why don’t you use the other stuff?
@wendypickford24783 жыл бұрын
You’re funny, but incase you’re not joking he means use a small amount of super glue.
@xoruss_5 жыл бұрын
Woah you call that cracked? I dropped mine on the street and it’s broken :’)
@apexmike8495 жыл бұрын
He must have only blown on it too hard, or maybe sneezed. Mine dropped from one filing cabinet drawer to another - 1-2ft and I had one of those rubber cases and the whole digitiser went - you just can't beat fate!
@AwsomeAlisha225 жыл бұрын
@@apexmike849 yep dropped mine down the stairs fully shaterred
@AZgule20105 жыл бұрын
I dropped mine from the moon and all I got was a scuff mark (I own a Samsung)
@squidballs4 жыл бұрын
I dropped mine from 1 foot *on its back side* and now I have a shattered screen , even though I dropped my iPad from my loft bed before and it was perfectly fine ; u ;
@culturedboor5 жыл бұрын
Will prying and heating work on super glue if you crack it again? Or is this a bridge burner?
@jackfrost21465 жыл бұрын
Definitely burnt his bridge. The screens usually come with adhesive tap attached--no glue needed.
@Covid-bv4hp3 жыл бұрын
bro that grounding cable thats ontop of the home button is so annoying to remove, is there any easier way to?
@KyleMoyer4 жыл бұрын
Does anyone know from experience how this compares to replacing the screen on an iPad mini 1?
@kamiacc59324 жыл бұрын
mr.best 556 idk but my iPad 5th gen like on the top I can’t press and the screen is bent so I’m tryna find a way to fix it
@TheFixTech4 жыл бұрын
It’s generally the same process if not a little easier...
@KyleMoyer4 жыл бұрын
@@TheFixTech Ok! it's either this or going to the recycling plant so ill give it a try!
@QueenLadivah3 жыл бұрын
Can an ipad 5th gen be replaced with 6th gen touch screen so it can use an apple pencil?
@TheFixTech3 жыл бұрын
Sorry but that is not possible
@romcallis5 жыл бұрын
Is the glue better than 2 sided tape?
@TheFixTech5 жыл бұрын
A lot of the double sided tape out there does not last and screen will start to lift. I use that particular type of glue that once heated will melt and screen can be removed for further repairs if needed. Some good quality double sided tape is good, most cheap ones are bad.
@leogoldberg60143 жыл бұрын
Don’t attempt without heat source i learned the hard way!!!!
@RMatner3 жыл бұрын
If the finger print touch button is already included in the replacement screen. Do you still have to change it with your old one? Or will the new one work the same? Thanks,
@TheFixTech3 жыл бұрын
The new one will work, but no Touch ID. Only original button has the Touch ID feature since it is coded to the main board.
@Nuyster73 жыл бұрын
After I replace the screen. It shut down by it self. Do u know why ?
@ViceStan5 жыл бұрын
You do realize that superglue evaporates, and leaves a white deposit, especially in an enclosed space?
@alexfedorenko37854 жыл бұрын
Stan Malikov what would you recommend?
@kingnlcrafter7394 жыл бұрын
Alex Fedorenko You have special stickers for screen replacements. They are made for it, and usually only costs a few dollars.
@christypittman97734 жыл бұрын
@@kingnlcrafter739 is there a specific brand or name recommended for the stickers?
@kingnlcrafter7394 жыл бұрын
Christy Pittman They don’t have a pacific brand as far as I know, just search “iPhone 6s frame sticker” or whatever iPhone or iPad you need.
@HarshKumar-mr3uq3 жыл бұрын
I mean screen digitiser cost
@TheFixTech3 жыл бұрын
Usually 10-20 dollars
@HarshKumar-mr3uq3 жыл бұрын
What is the cost of it
@yapperyup5 жыл бұрын
Hey can u comment the link to the glass that you bought please
@PracticaProphetica5 жыл бұрын
This seller worked for me (I'm in Canada): www.ebay.ca/str/Axiology-Imports-Canada
@hugothomas9893 жыл бұрын
Some people actually disconnect the battery, is it necessary?
@DragonSlayerSwe2 жыл бұрын
No. But comes with a higher prize if you fail...
@crazycaker78694 жыл бұрын
Wait do you need the warmer thing?
@mahektailor45425 жыл бұрын
Do it have same digitiser and 2018 and 2017 ipad ?!
@eflex595 жыл бұрын
Mahek Tailor I think so
@yass3r2365 жыл бұрын
Basically the 2018 digitaliser is better you better buy one if you can afford it but the iPads use the same digitaliser like its supported on any ipad
@superchelsea965 жыл бұрын
You're supposed to block the battery before disconnecting the screen!
@chiefskingdom53783 жыл бұрын
What if the glass is completely shattered and you can’t get the screen off in one piece and the glass breaks too easily
@TheFixTech3 жыл бұрын
Takes longer to remove, but is possible
@shubhamjagtap61942 жыл бұрын
@@TheFixTech p
@stevenrogersfineart42242 жыл бұрын
Use packing tape or scotch tape over the screen to hold the glass in place. Just like they do with windows before a hurricane :)
@peachcityshankar11743 жыл бұрын
👌🙏🙏😎
@widebodyj6 жыл бұрын
Where is the sound?
@danivanpolen6 жыл бұрын
I ate it
@apexmike8495 жыл бұрын
If you reach down the back of your trousers...
@alekshernandez25 жыл бұрын
he is mute
@Calbenmike4 жыл бұрын
This video needs sound.
@troydavis52173 жыл бұрын
Thank you for that comment. I thought sometime was wrong with my laptop until I saw your comment.
@sneakysasquatchgameplay76333 жыл бұрын
Can someone send me a link through this comment for the most cheapest iPad screen (5th generation)
@ls430075 жыл бұрын
Well i guess nobody’s ever opening that thing again
@lucianovazquez36124 жыл бұрын
MichaelDoesStuff Videos my uncle
@markowen61505 жыл бұрын
Nah. I’d rather pay to have this done. Too many steps and places to totally mess your iPad up
@djenn4344 жыл бұрын
You pay someone to do everything don't you? lol
@Weezyb283 жыл бұрын
Why isnt there no fkin sound
@adzmitch3 жыл бұрын
Do not use super glue.
@garenmatossian75745 жыл бұрын
I threw my phone on my bed and it cracked
@cozz1245 жыл бұрын
What type of bed do you sleep on
@yass3r2365 жыл бұрын
I threw my iPad on my bed and it cracked !!!! I swear
@kaelynstalling83064 жыл бұрын
I broke my iPad
@pjoter34554 жыл бұрын
Omg, super glue! You’re lame af 😱
@alekshernandez25 жыл бұрын
what a cheap way of replacing a glass.....blade, dangerous, no heat at the beginning, harder to accomplish, no heat monitoring, you can fuck up....using just any glue?... cheap ass repair... dust and micro bacteria will be accumulated over time in the gap between the glass and frame.. Sorry, I wish there was a button "Do not attempt this"