How to Replace EVAP Purge Valve Solenoid 07-14 Escalade P0496

[@LivinginMariettaGA]

Thank you! Excellent video. Did a great job of stopping to show & explain each step. Easy replacement on my 2010 Cadillac Escalade ESV.

[@GreeksGarage]

Thank you! I’m glad I could help. 👍🏼

[@agresham1982]

Thanks. Took me less than 15 minutes to do on my 2012 Cadillac Escalade ESV.

[@cuivincent9744]

Very intuitive . and lots people said I have to replace the carbon canistor to eliminate the code, your case told me the other possibility.

[@michaelisrael991]

Same here, gonna do the canister this week.

[@SPCBOE]

Thanks a lot. My 2007 Escalade wouldn’t immediately start whenever I put gas in it. This fixed the problem.

[@GODZILLA20008]

This really helped me out, great step by step!

[@jasonwilson1864]

I have an 06 that had the same problem. The set up is a little different but the same concept. The vidoe was very helpful. Thank you

[@GreeksGarage]

You’re welcome, glad I could help.

[@brianandrew8033]

Thanks so much. Your video was perfect and helped me swap this part out in under 10 minutes. You rock.

[@GreeksGarage]

I’m glad I could help! 👍🏼

[@johnmoustakas8090]

Very good video. Clear and concise. Thank you.

[@BringBackMasculinity1987]

My father n law is replacing this on our 13 Yukon as we speak. Thx for the video

[@GreeksGarage]

Your welcome, I’m glad I could help. Thanks for watching 👍🏻

[@angel.aguilera7727]

Love this video, perfect instructions and perfect set up and didnt skip a step. Thank you sir!!

[@krisriley83]

Thanks for the well done video describing the replacement.

[@chatobalencian1504]

I have a 2007 cadillac escalade and the code I'm getting is p0496 i just ordered the evap that goes under hood ill be replacing this next if that doesn't take the code off also my vehicle will just shut off while im driving and it will say reduce engine power i took the throttle body off and cleaned the crap out of it and it was very dirty so far it has not turned off since i cleaned it i was going to replace the throttle body sensor next but it seems to be working good so far just had that code pop back up again P0496 thanks for the help

[@joe8schmoe]

I had a strong gas smell in the vehicle, but no codes. When cold, the truck also cranked longer than normal before firing up and running normally. Replacing this fixed the starting problem and also took care of most of the smell. The next day, it told me to tighten the gas cap, which I had done the previous day, so I replaced that as well.

[@rolling_wit_cedphillips7408]

Thanks your videos are super informative and helpful.

[@GreeksGarage]

Thank you! And thanks for watching.

[@CrispSugar]

I swear your video is so calming for me. The only thing is, I’m getting this code, my car starts but slow to accelerate. Any other possible reasons this is happening?

[@GreeksGarage]

Is the check engine light on? If so, I would see what codes are coming up. Thanks for watching.

[@Jerry-ATCTA]

Thank you for this video! Helped a lot, perfect!

[@kevinhoupt6145]

Will this cause you having a hard time filling up gas?

[@eaauto6182]

Yea think so mine only goes to 3/4 tank and has starting issues after filling up

[@edwardgarcia9170]

What about that hose that goes towards the back. What if it’s not plugged in

[@aliciacarter6210]

More info where does the hose to this run

[@printflips1279]

Thank for video. I have this elm) Tell me please what app do you use?

[@GreeksGarage]

The app is EngineLink

[@viper200075]

Nice job

[@zc3nt1]

Just want to mention, you called it a vent valve. That is totally separate from the purge valve. What you changed is the purge valve which is the (front door) the actual vent valve is the back door. It’s good to note that.

[@DevonBbrown]

I was wondering if anyone else noticed this...

[@ositopanda7312]

Is the same think for 2005 Cadillac scalade o not

[@zc3nt1]

And also the codes what you might get is a lean or rich code. As the purge valve is vented into the manifold. So the purge valve (theoretically) vents the fumes from the evap into the engine to burn. If your purge valve is bad it’s constantly sucking vacuum. So it will clean out all the fuel. It may throw a p0172 code for rich.. until it’s cleaned out all the fuel trapped in the evap. Then it will go p0174 and p0171 for lean. Because after it’s filtered all the fuel.. it will just suck air. So a bad PURGE valve can cause a lean OR rich code. And BEST to use a factory GM part.

[@ChevySS1968]

Thanks for this, I am having P0171 & P0174 together, so I was wondering if this purge valve just might be the culprit. Much appreciated!

[@thomasdeloach5716]

This was great thank you

[@johnvalyo9417]

Great video!! Thank you so much!!

[@infernalmonolizer2539]

is it the same thing with a 2016 escalade ?

[@shortdoggcouncil1]

How can you tell its not the one at the tank.

[@redneckweekly]

Thanks for the how to. Great video!

[@williamm.smithwhatscoperin8849]

How to change SU 1390 VPSA1 part PO446 on Cadilliac Esclade 2006 ESV

[@DEVILS_advocate05]

I have p0442 code. What is the fix suggestion

[@montyshelby]

Thanks 👍 very informative

[@donovancamelin9100]

Thanks for the video bud!

[@bizzieone]

Is this the same fix for a p0449 code?

[@kittshausman6191]

Thank you so much😊

[@mrshyboi1]

I changed my purge valve just new and did a quick drive around the block .. the check engine light turned off but now it looks like i have some white smoke coming out the exhaust

[@adog1275]

Did you ever figure out what the white smoke was coming from? My check engine light just started popping on for this code and I’m going to replace the purge valve this weekend just tryna see what other issues I may run into

[@phillipcastro2394]

​@@adog1275White smoke might indicate the pvc valve

[@tinorenteria7831]

Awesome help!!!!!!!

[@Lmm_Micha]

I have same truck and a p0304 code and I changed plugs and wires and coil packs and still can’t figure it out any suggestions ? Engine light flashes and stabilitrak and all that

[@codac9098]

Figure this out? Mine is doing the same thing.

[@LeskoBrandon2x]

Will this video help me with a 2005? Also, will the check engine clear upon repair, or will I have to manually clear it? This was the only error read when I diagnosed it

[@GreeksGarage]

Q the 2005 is set up a little differently, but if you do a quick search on it, there are a few videos showing how to do it. It’s basically in the same location, just mounted vertically and held in with a bolt. Thank for watching.

[@LeskoBrandon2x]

Greeks Garage thank you!

[@johnmichael9354]

I’ve changed that part and the one near the gas tank and I still have the same code. What could it possibly is?

[@GreeksGarage]

I would check all the hoses to see if there are any cracks in it. Any little leak would cause the code to come on.

[@tktk-om8cg]

Other than these smaller problems is escalade pretty reliable

[@Livingandcooking]

Yes they are

[@eaauto6182]

As long as you don’t have active fuel management

[@marioprado7066]

I have a problem with my Escalade at the first time every Day it will start perfectly but after that it has truble starting again... could this be the solution???

[@angelislas7819]

Did you ever figure what that was ? I’m having that issue now

[@phillipcastro2394]

​@@angelislas7819been trying to figure this same problem out mine will start fine then die out an wont start again till the morning im going to try the evap vavle maybe the fuel filter then the spark plugs dont know whats wrong with this thing

[@KingTeddy1]

This worked for my 2008 Cadillac Escalade. But, I'd like to add DO NOT buy a cheap EVAP PURGE VALVE from Amazon you'll have more problems than its worth. Each one I bought from Amazon works but it starts ticking pretty loud. It did stop until I bought an OEM part

[@turvonc]

Easy...thanks

[@saintalvarado4436]

Part #?

[@GreeksGarage]

Saint Alvarado I got it off of Amazon. If you look up Evap vent solenoid for the year of your car on Amazon it should pop up.

[@kennygarcia102]

My code was P0442 emissions small leak

[@drybonesmalone6974]

i really hate when you car guys dont show the symptoms in actions