How to Replace Front Lower Control Arm Bushing 2008-2012 Honda Accord

Buy Now!
New Control Arm Bushing Set from 1AAuto.com trq.video/ic-1...
New Control Arm Bushing from 1AAuto.com trq.video/ib-1...
This video shows you how to install a front lower control arm bushing on your 2008-2012 Honda Accord. Rubber bushings help smooth out a ride, but are susceptible to wear or drying out and crumbling over time. This bushing is replaceable separate from the control arm, and you can replace it yourself.
This repair was done on a 2010 Honda Accord LX-S 2.4L Coupe 2-Door FWD Manual and the process should be similar on the following vehicles:
2008 Honda Accord
2009 Honda Accord
2010 Honda Accord
2011 Honda Accord
2012 Honda Accord
Tools you will need:
• Pry Bar trq.video/omm-...
• 15mm Wrench trq.video/om6-...
• 17mm Wrench trq.video/om6-...
• 17mm Socket trq.video/oNG-...
• 19mm Socket
• Pliers
• Air Chisel
• Ratchet trq.video/oSy-...
• Torque Wrench trq.video/ozf-...
• Brake Grease
• Jack Stands trq.video/onj-...
• Rubber Mallet
• Vise
Subscribe: / @trq
Check out our playlist:
Honda Accord 2008-12 8th Gen: • Honda Accord 2008-12 8...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@ItsAlive111]

Thanks for the video but it's weird that you only changed that small rear bushing instead of the bigger one in the front that is most likely to start cracking. Or just replace all 3 of them at that point.

[@gregrivera8520]

hey bro you do good work. my question to you is, what size cup is that? or what size socket can I use to do it? I can't seem to find it on eBay or otherwise.

[@yohkodevilhunter8292]

What tool (cap) was it you used to drive the bushing in?

[@Brincandopabajo]

That is not easy.