How to Replace Fuel Injectors on Honda V6 engine - 1988 Acura Legend

  Рет қаралды 3,211

6th Gear Garage

6th Gear Garage

Күн бұрын

Today I'm working on the $350 1988 Acura Legend that has been sitting for 10 years. The new rebuilt OEM injectors have arrived, so let's see if they will finally get this Honda v6 running smooth.
Last time I installed a new Cap, Rotor, Fuel Filter, Plug wires, and fresh Oil/filter: • 1988 Acura Legend Tune...
Two weeks ago, I replaced the ECU because I think the old one got wet from the leaking sunroof while the car sat. After a lot of cranking, the car finally started but ran rough: • First start in 10 year...
Before that, I replaced the fuel pump, checked the timing belt, cap and rotor: • 1988 Acura Legend Fuel...
First, I put a battery in it and found some electrical problems, bad fuel pump, and a LOT of water under the carpet: • 1988 Acura Legend Rest...
Here's the original video walk around of this 1988 Legend: • $350 1988 Acura Legend...
I don't have Patreon or ask for donations but you can support the channel with some rad gear from my store: 6thgeargarage.c...
Follow Us:
Instagram: 6th_gear
6thGearGarage

Пікірлер: 20
@TheDutyPaid
@TheDutyPaid 3 жыл бұрын
Give that rev counter a tap with your knuckle, the needle may just be stuck lol Always fun to see an old car have a new life and good video too.
@6thGearGarage
@6thGearGarage 3 жыл бұрын
I will try that first! I read the solder joints on the back can crack over time.
@oldapple101
@oldapple101 3 жыл бұрын
I put new seals on the injectors in my ‘89 sedan earlier today, idles smooth as silk. First gen Legends are definitely a lot more solid than they get credit for
@6thGearGarage
@6thGearGarage 3 жыл бұрын
I'm starting to really like this car!
@sergo_gg5601
@sergo_gg5601 2 жыл бұрын
Hi i have Honda Legend coupe with this engine after winter engine dont start and ecu dont show eny errors What voltage should be on the wires that are connected to the injectors when Ignition on
@6thGearGarage
@6thGearGarage 2 жыл бұрын
I don't know the voltage, but usually the first component to go bad on these cars is the main relay located in driver lower dash area.
@drake_sapphire
@drake_sapphire Жыл бұрын
do you by chance have a linkto where you bought the refurb injectors? i cant find some to save my life.
@6thGearGarage
@6thGearGarage Жыл бұрын
Yes these are the ones I purchased: www.ebay.com/itm/122247715202
@drake_sapphire
@drake_sapphire Жыл бұрын
@@6thGearGarage Ty so so much !
@timcollins7207
@timcollins7207 2 жыл бұрын
Any chance you could link me to where you got the injectors from? Cheers.
@6thGearGarage
@6thGearGarage 2 жыл бұрын
www.ebay.com/itm/OEM-Genuine-Honda-Set-Of-6-Fuel-Injectors-for-V6-2-5L-2-7L-3-2L-/122247715202?mkcid=16&mkevt=1&_trksid=p2349624.m46890.l49286&mkrid=711-127632-2357-0
@tommcl8548
@tommcl8548 3 жыл бұрын
👍
@jhondeivysequeviarunca5139
@jhondeivysequeviarunca5139 3 жыл бұрын
Un favor me puedes decir la medida de calibración de valvulas de ese motor por favor
@6thGearGarage
@6thGearGarage 3 жыл бұрын
Sorry, I do not know. I have not adjusted the valves on this engine.
@elgeneralxx
@elgeneralxx Жыл бұрын
I just replaced the injectors on my 1989 Acura legend and did everything right now it sounds horrible
@6thGearGarage
@6thGearGarage Жыл бұрын
Did it run good before replacing the injectors? Where did you get the new injectors from?
@elgeneralxx
@elgeneralxx Жыл бұрын
@@6thGearGarage it was leaking fuel before from the bad o rings thats why i replaced them. i bought them new for my 1994 Acura legend and they are remanufactured. The engine now sounds like it has clogged injectors
@6thGearGarage
@6thGearGarage Жыл бұрын
@@elgeneralxx so you put injectors for a 1994 on a 1989?
@elgeneralxx
@elgeneralxx Жыл бұрын
@@6thGearGarage yes they are specifically made for 1986-95 model Acura and honda. But im guessing that may be a issue. Just bought a fuel rail off ebay for a 1988 model and should i buy new fuel injectors again?
@6thGearGarage
@6thGearGarage Жыл бұрын
@@elgeneralxx The second gen Legend has a different engine, so maybe you have those injectors. I'd try some specifically for 86-90 with 2.7L engine.
How To Remove Acura Legend Front Bumper + Headlights - 1st Gen
4:13
6th Gear Garage
Рет қаралды 3,6 М.
How to: Prep and Paint an Engine with Aerosol Spray Cans
24:56
6th Gear Garage
Рет қаралды 7 М.
У ГОРДЕЯ ПОЖАР в ОФИСЕ!
01:01
Дима Гордей
Рет қаралды 7 МЛН
Angry Sigma Dog 🤣🤣 Aayush #momson #memes #funny #comedy
00:16
ASquare Crew
Рет қаралды 49 МЛН
Touching Act of Kindness Brings Hope to the Homeless #shorts
00:18
Fabiosa Best Lifehacks
Рет қаралды 18 МЛН
The FIRST custom Hydrogen powered vehicle selling to the PUBLIC!
50:23
Flying Sparks Garage
Рет қаралды 37 М.
Toyota CEO: Our New Engine Will DISRUPT The Industry!
9:21
ChargeDrive
Рет қаралды 120
19 Incredible Classic Car Treasures Found and Ready for Purchase
18:23
Affordable Classics
Рет қаралды 1 М.
Finally Reassembling my 1980 Toyota Pickup Rat Rod Build
25:07
6th Gear Garage
Рет қаралды 12 М.
How to Prep and Paint the Underside of a Truck Cab
13:02
6th Gear Garage
Рет қаралды 4,5 М.
Laser Cleaning Magnesium with 200w Pulsed Laser Cleaner
7:42
6th Gear Garage
Рет қаралды 1,5 М.
1980 Toyota Pickup Rat Rod 20r FIRST START!
11:53
6th Gear Garage
Рет қаралды 3,6 М.
У ГОРДЕЯ ПОЖАР в ОФИСЕ!
01:01
Дима Гордей
Рет қаралды 7 МЛН