How to Replace Fuel Pump E7093M in 1996-1997 Dodge Ram Pickup

Applications:
97-96 DODGE RAM PICKUP 239 (3.9L), 318 (5.2L), 360 (5.9L)
97-96 DODGE RAM PICKUP 488 (8.0L)
This video is about how to replace the fuel pump modular assembly E7093M in a 1996 Doge Ram. Airtex is committed to providing the most up-to-date, in-depth fuel pump replacement information that professional technicians need to diagnose, repair and install today's complex fuel delivery systems. Airtex is the only U.S. automotive aftermarket manufacturer that designs and builds electrical AND mechanical fuel delivery system components, including modular reservoir assemblies, electric fuel pumps, mechanical fuel pumps and in-tank sender and hanger assemblies, for a full range of car, truck, fleet and specialty vehicles.

[@G3TAcademy]

I bought a fuel pump for a 96 dodge ram and a 99 dodge durango. Both Airtex pumps purchased from Global Automotive on EBay. Both installed by a professional shop, and both lasted less than 3 years before going bad.

[@tomlopez2868]

Hi. Just wanted to let you know figured out the fuel pump problem , It helps when there is enough gas in the tank! got gas in it it works great. I think I need to get BLONDE STAR installed.but ty for the help.

[@ranytravis4953]

How do I get to gas tank by removing almost all the bed bolts and tilt bed up ???

[@L35inColorado]

If you can't lift the truck to remove the tank from below, and instead you want to tilt the bed to gain access to the pump, here is a video: kzbin.info/www/bejne/qpyyhpeCfslog80 I'm a woman and as able to do the job alone -- I was able to lift the truck bed (long bed) using my legs to push it up, but most men could probably lift it with their shoulders. It is a good option if you don't have a lift, or any way to remove the bed entirely. Good luck, everyone!

[@juanolivas2637]

thanks 4 this video

[@Juan-we2og]

Oh and thank u soo much for the video

[@magdalene74]

pump does run for a second on keyturn, so its not a wiring break.. my next thought was the fuel regulator but im not even sure I could identify it, my local autozone only sells the assembly and im not sure if the regulator would be included or not.

[@indiehandstudios5711]

you didnt say anything about the float.. witch way is it suppose to attach to the pump

[@ShermX69X]

The lubricant used on the grommet is most likely silicone based. I'm thinking it was probably "Sil-Glyde" that you can pick up from NAPA for about $8 bucks. "Grease consistency stays put and won't drip off like silicone oils. Harmless to rubber and car finishes. Suggested applications: Trunk seals, rubber bumpers, speedometer cables, brake parts, window channels, hood strips and pads, rubber gaskets, and belts." In fact now that I think about it you could get away with just using those same little silicone packs part stores ask you if you want when you buy brake pads. (Just use a little bit.)

[@albertobastida6968]

Thanks

[@AirtexFuelPumps]

you're welcome.

[@1risingangel1]

Looking on how to diagnose this on a 1997 dodge b1500 3.9 van

[@Juan-we2og]

What kind of lubricant do u use

[@Chubbzterrr]

What can I do if I don't have a harness adapter???? My brothers truck has the 6-prong thing but the adapter on the fuel pump is a 4-prong. My dad bought the fuel pump by itself at a junk yardish place.

[@kiddmike702]

How can I fix my gas meter ? It doesnt go uo when I put gas ? And my temoerature metter doesnt work either how do you fix that ?? Any suggestions??

[@Technoboy63]

Thanks for this video change my fuel pump yester day after I broke down thanks man

[@Erick3263]

Hi I have an 96 dodge ram pickup. Ever since I had this truck the gas gauge shows that its empty even when I put gas. Do you think replacing the fuel pump like this video will fix the prob? Thanks

[@monteispep]

Mine does the same. Did you ever find the reason?

[@stephencboyer2003]

What is the short black cap beside the electrical connection on the new pump that is held on with a metal clip. Mine is cracked from weathering and fuel is leaking from it

[@stephencboyer2003]

Good look at it at 4:50

[@dusteyrose5883]

fule pump NOT module

[@generaltso762]

So do you leave that little black cover with the clamp on it

[@blakekimmel2995]

Our previous mechanic discarded the carry over portion on the top of the assembly, now we have a gaping hole in the top of the fuel pump assembly. Is it possible to buy that fitting somewhere or must we do pick and pull from a junk yard?

[@celesteadvm]

I got one on amazon the Mopar 52127666 Valve. Hopefully will fit in my 96. Still trying to find the rubber part.

[@kiddmike702]

okay great thanks

[@tomlopez2868]

ok now my next problem is the headlights go on and off at random. a friend said Dimmer switch. so having said that is there anything else I need tto look at before I tear the steering wheel apart, like fuse breaker anything?

[@magdalene74]

truck wouldn't start so we pulled the fuel line off at the intake valve, no gas was present, listening to the gas tank no pump sounds, pulled the gas gauge assembly out, hotwired the fuel pump alone to check it, runs fine. Next?

[@adriananoelle4699]

I’m surprised an “ase” mechanic didn’t abide by torque specs on strap nuts which are 30ft lbs.

[@tomc8157]

German torque. Good n tight.

[@maxwell932]

Where is the fuel filter at ....my 97 ram 1500 5.9 isnt showing any filter on the rail or anywhere

[@AirtexFuelPumps]

The fuel filter is inside the fuel pumps reservoir. It is not a serviceable part.

[@turbolube1812]

What it's the part number for the rubber grummet? Or where can I buy it?

[@celesteadvm]

Same question. Can’t find the right one. Did you get it?

[@albertobastida6968]

where is the localization the gas filter, in a dodge ram pick up magnum 5.2L 2000 model

[@AirtexFuelPumps]

The fuel pump module has a filter in it; the pick-up, there is also a strainer integrated into the fuel pressure regulator in the top of the fuel pump module. There is not a filter inline between the tank and the engine.

[@stevestone6936]

This is very easy.......IF you know what you're doing .

[@AirtexFuelPumps]

Now, after watching the video, you know how to do it... making it easy. Well, a little easier I hope. Thanks for watching, thanks for the comment!

[@dk101motocross]

Need to know where to get that pig tail adaptor asap

[@erisprimera8774]

amigo q regulador de gasolina le puedo colocar a una dodge ram 97, que no sea el original si no de otro vehiculo.

[@ghobrial68]

my dodge ram 96 stalls and sputters after i hit snow bank or sudden stops can it be shut off valve

[@tomlopez2868]

it is a new Airtex pump

[@tomlopez2868]

ok just got done replacing my fuel pump 97 Dodge ram 1500. my problem came when reinstalling the wires to the new adaptor the red retaining clip that holds the plugs together broke. it slides back and forth but will not lock the plugs together like it should. Any ideas will help as to what to do at this point.

[@TheMarcoBoscolo]

What type of lubricant is used on the roll over valve seal?

[@june9684]

How do you remove fuel from the tank when the 97 Dodge Ram has a restrictor?

[@biggwake42]

i have a 1997 ram 3500 v10 truck is hard to start. I have the fuel pressure test kit. I installed it started the truck and the psi is over 80 psi when I turn the key to on position the gauge doesn't move. can you give me some advise..

[@biggwake42]

Thanks alot your video was great..thanks for the fast response

[@aboomeerabdusalamfaiz1749]

Hi i have 2011 dodge ram slt 2500 5.7L Hemi ,i wen to mechanic he told me you need to chane the fuel filter not a pump,so where could i find the filter. plz help

[@josecorona2553]

its the whole thing

[@tomlopez2868]

When I cycle the key severl times it will start or try to start but it won't stay running

[@tomlopez2868]

First I want to say THANK YOU! for this web site. MY ?. what do you do about low pressure?

[@robertmack7039]

I HAVE A 1999 DODGE RAM 1500 9.2l with code no bus just install new pump

[@mrboby5]

que es lo que sacas de la bomba en el minuto 3:00 ?

[@sherryhubler3415]

When I changed my fuel pump on my dodge 97. Instead of taking the roller valve from old pump I just sealed it off. Truck ran great first day. Next morning I started it up and gas is pouring out of tank under truck. Could it be because I didn't put the roller valve in New pump??????? Help

[@blakekimmel2995]

Did you ever figure this out? Our previous mechanic discarded the carry over valve and its almost impossible to find a new one. Is it possible to seal without that?

[@celesteadvm]

Mopar 52127666 Valve i found this valve. Will try in my truck.

[@betulie11]

Is there a place I can buy just the 6 pin to 4 pin adapter?

[@betulie11]

+Airtex Pumps OK thanks for the quick reply!

[@donaldwlackey439]

Airtex/ASC Performance Pumps

[@KALEMBORECORDS]

hi, I'm Very Stressed with my 99 Dodge Ram 1500 V8 5.2 motor. I replaced the pump 2 times and my gas meter still going up & down. (The tank is full of gas but the meter is telling me that the tank is empty. Do you have any suggestions???

[@1risingangel1]

Notice such emptyp

[@johnjackson224]

What is the name of that black part at 1:46 of the video? I broke it trying to get the fuel pump out and cant find it anywhere.

[@sarahwright2488]

John Jackson what was it called

[@ItsMeUrDaad]

purge valve

[@celesteadvm]

Mopar 52127666 Valve

[@ShermX69X]

@@celesteadvm 👍🏾

[@gbcsince1976]

My 1997 Dodge Ram 3500 is in the shop having my pump replaced right now. It really isn't that hard to do, I just write a check for $ 650.00 and I am back and running...................

[@sherryhubler3415]

It's a 97 dodge ram won't stay running . And gas pouring under truck

[@martinsigala9510]

Is the fuel pump the same as ext cab as to a single cab? would they be the same? I have the ext cab

[@martinsigala9510]

+Airtex Pumps thank you! how do I order an Airtex pump? just go to your website?