How to replace goodman fan control board

Heat Pump Repair
when your heat pump has failed, call the heating experts in the triangle, Expert Express. Our technicians are highly experienced, servicing all heat pump brands including Trane, Rheem, York, Temp Star, Ruud, Bryant, Carrier, Goodman, and Amana, among others.
Heat Pump Replacement
If you need your heat pump replaced, we'll bring the right one to you and install it professionally, usually in minutes. We'll help you choose the right heating solution for your home, based on your home's needs, and your budget.
Frequently Asked Questions
Does a heat pump really run backwards in the winter?
How Heat Pumps work
No, this is one of the wildest of all tales that never seems to die. A heat pump actually runs the same way all the time, never in reverse or backwards. It collects heat from the outside air and transfers it indoors, where a fan unit can blow it through your home. Similarly, it removes heat from your home in the summer and transfers the heat outside. You can experience this by placing your hand over the condensing unit outside in the summer. You will feel extra hot air blowing onto your palm.
Is it cheaper to run a heat pump or a gas furnace?
A clear-cut answer has not been reached upon yet. The truth is that a heat pump is less expensive in the winter at temperatures above 40° Fahrenheit. Correspondingly, a gas furnace (propane or natural) is the least expensive at temperatures below 40° Fahrenheit.
Is there a way to get the best of both a heat pump and gas furnace?
Dual Fuel Heating
Yes, you could invest in the dual fuel system. We can provide you this system that is becoming very popular. Using a dual fuel HVAC system in the house can give you the best of both worlds. The heat pump works at temperatures above 40° Fahrenheit and the gas furnace works at temperatures below 40° Fahrenheit. As there are no “heat strips” or electrical resistance heating coils on the dual fuel system, the gas furnace acts as the back-up or secondary heating system for the heat pump instead of the “heat strips.”
Is there any difference in the summer between the use of a heat pump and a straight A/C unit?
No, as long as the SEER (Seasonal Energy Efficiency Ratio) rating is the same for both. Air conditioning condensing units are placed outside on a pad and are connected to an evaporator at the end of a gas furnace by means of Freon lines. Condensing units and evaporators have to be “matched” by the manufacturer to achieve the desired SEER rating.
We are the heat pump repair experts
For the best service and rates in Raleigh, Durham, Wake Forest, Cary & Chapel Hill, call our offices now to schedule an appointment or visit our contact page.
NATE Certified We have highly trained and certified heat pump repair experts. Our techs are Nate certified licensed bonded and receive weekly training to ensure your heat pump is working better than ever after our service.

[@wisdomwisdom817]

Awesome job thank you so much

[@MsFishingdog]

great video.

[@thomaswerts2418]

Nice work

[@michaelpodielski6071]

good vieo....nice troubleshooting,,,well done sir

[@murphyclark4365]

My purple wire going into the relay is fried what can I do about that

[@renecuevas4128]

Put another one same size

[@andrewdudley4803]

Are these motors 120 or 240

[@renecuevas4128]

240 volts

[@wisdom-for-life]

Where can I find the wires for this part? A couple of them were fried....

[@wisdom-for-life]

Never mind.... They are just regular 14 or 16 gauge copper (stranded) wires that you can get from home depot.. Just make sure you buy some of the little clips at the end of the wire too.

[@Gunjack1440]

Lol anyone see the flex burn. Nice video i may switch to a turbo torch after seeing that.

[@sebastian-gi6gk]

have one like tha its burner de fiuce

[@taylors5466]

Are these fan control board only to be used on heat pumps? I have an old gas furnace fan control board (limit and valve control as well) that I'm looking to replace.

[@jerryvarnum3785]

I see that the new Goodman board have the 3V fuse but the old one doesn’t have the fuse receptacle at all. I was told this was not good to do? Can you respond with why you changed it to the Fused board?

[@renecuevas4128]

Old style do not have fuse. But new style have it ....true

[@b-riair9114]

I heard you say it was low voltage

[@b-riair9114]

That purple wore to the normal open on the fan relay isn’t high voltage

[@renecuevas4128]

True u can not mix high n low volt on contact side of relay. True

[@kennyb2357]

There is no low voltage on that relay.

[@renecuevas4128]

True

[@b-riair9114]

Wire I mean

[@mpugliano]

Why don't you touch that low voltage going into your relay @ 1:20. Not to knit Pick but voltage doesn't come from the thermostat, 2:05 . That would be like say voltage coming from the light switch. You shouldn't teach if you don't what you're doing. Teaching would include diagnostic steps to identify failure. Not misidentifying high voltage for low.

[@renecuevas4128]

True he is rough. No pliers but he means good. This job is 225 plus tax specially in the attic Regular closet is 175 plus tax