How to Replace Passenger's Side CV Axle 2001-2007 Volvo V70

Buy Now!
New CV Axle Assembly from 1AAuto.com 1aau.to/ic/1AACV00507
This video shows you how to install a passenger's side CV axle on your 2001-2007 Volvo V70. A CV axle has flexible joints. Often, these joints wear out, or seize from contaminants due to the protective boot tearing open. A worn joint is prone to breakage, or other hazards. If your vehicle needs a new CV axle, install a quality TRQ axle that is engineered to your vehicle’s specifications.
This process should be similar on the following vehicles:
2001 Volvo V70
2002 Volvo V70
2003 Volvo V70
2004 Volvo V70
2005 Volvo V70
2006 Volvo V70
2007 Volvo V70
Tools you will need:
• Pry Bar 1aau.to/oIC/1AXAA00020
• 19mm Wrench 1aau.to/oLE/1AXAA00010
• 12mm Socket 1aau.to/oa3Q/1AXAA00015
• 13mm Socket 1aau.to/oa3Q/1AXAA00015
• 18mm Socket 1aau.to/o2q/1AXAA00043
• 19mm Socket 1aau.to/o2q/1AXAA00043
• 21mm Socket 1aau.to/o2q/1AXAA00043
• 1/2 Inch Impact Gun 1aau.to/ont/1AXAA00252
• 3/8 Inch Impact Gun
• Torque Wrench 1aau.to/oamt/1AXAA00044
• Anti-Seize Grease
• Gloves 1aau.to/ozq/1AXSS00048
• Safety Glasses 1aau.to/otv/1AXAA00343
• Floor Jack 1aau.to/oQc/1AXAA00068
• Hammer 1aau.to/oLd/1AXAA00091
• Punch
• Rubber Mallet 1aau.to/ofe/1AXAA00413
• Wheel Chocks
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@HereXEG]

Could have turned the wheel and the shaft at the hub will come out. No need to take strut or tie rod off. Just make sure to jack the car up while leaving the A-arms falling down. No need to realign if you don't unbolt the strut.👍

[@karinaalvarez7562]

so helpful, thank you so much

[@intsstrals90]

Nice vid..helped me alot! Even when doing it on the ground,it was way easier. Biggest struggle was getting shock absorber back to knuckle. Otherwise..easy as pie. Cheeers from Latvia!

[@TRQ]

+Ints Štrāls Thank you! We love empowering our customers and showing how to perform DIY auto repairs with our high-quality auto parts. 1aau.to/m/Shop-TRQ

[@CaptainSeamus]

Anyone else ever have a problem with the carrier bearing sliding along the intermediate shaft, causing the splines in the transaxle/angle gear assembly to disengage and lose all power to the wheels, or has it just been my bad luck twice on AutoZone half shafts? Car is a 2004 S60R with AW71 auto. The fix is to use 640 sleeve retainer or 271 hi strength thread locker on the shaft, and then repress the bearing (which doesn't seem to be too much of a press to move to place).

[@kazparzyxzpenualt8111]

Torque your carrier bearing nuts to 70 then 90° turn more before replacing the belly pan!

[@bradleyhovan9390]

Great video! Does the bevel gear not lose fluid when pulling the old axle?

[@fuckumaddafakka8529]

I like this approach more than the other I've seen where you're supposed to force the lower control arm out of the way using a ratchet strap from underneath that will strain the rubber bushings like crazy. 👍

[@tomdeklerk7616]

Great video! Is I presume this is an automatic? I don’t know if there are differences between auto and manuals

[@sketchbreaker]

2008 xc70. Will any transmission fluid be leaking out during this process?

[@nathanhiggins1438]

i didn't see any retention rings or snap rings on there, is that the case? I actually have a 2010 but having a hard time finding this info

[@jamieday6602]

Great video thank you!

[@user-cd5ye2pz5m]

Was it still connected to the lower control arm

[@klopsik696]

What if the torque on last bolt was higher than 35Nm?

[@ittaiubaldo3851]

I need for Volvo S60R 2004 Manual Transmission M66 AWD CV JOINT AXLE FRONT RIGHT AMERICAN MARKET

[@BoostedT5R]

SAME😭😂

[@HhhGggg-rz7bu]

That angle gear looks drenched in gear oil 😂

[@jeffflowers729]

I'm trying to change out my drivers side. When I pulled on the axle it came apart and the last piece is stuck in the transmission. I can not get it to pop out even driving a wedge in. If I pull this passenger side will I be able to see the end of the driver side to bang it out from this side?